Free English CRATE CA10 (01) PDF Document. Free English CRATE CA10 (01) PDF User Guide. Free English CRATE CA10 (01) PDF User Manual. Free English CRATE CA10 (01) PDF Owner Guide. Free English CRATE CA10 (01) PDF Owner Manual. Free English CRATE CA10 (01) PDF Reference Guide. Free English CRATE CA10 (01) PDF Instruction Guide. Free English CRATE CA10 (01) PDF Reference Manual. Free English CRATE CA10 (01) PDF Instruction Manual. Free English CRATE CA10 (01) PDF Operating Instructions.
CLICK HERE TO DOWNLOAD CRATE CA10 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the functions of the front panel controls on the CRATE CA10?
The front panel of the CRATE CA10 has the following controls:
1. INPUT: This is the input jack for your guitar. Plug your guitar cord into this jack.
2. LEVEL: This controls the output level of the amplifier.
3. LOW EQ: This serves as the bass control. Adjust this control to get the best sounding bass response for your instrument.
4. MID EQ: This serves as the midrange control. Adjust this control to get the best projection and midrange tones for your instrument.
5. HIGH EQ: This serves as the treble control. Adjust this control so your high notes and harmonic overtones are lively but not overpowering.
6. CHORUS ON/OFF Switch: This turns the chorus effect on and off.
7. CHORUS RATE: This controls the ripple speed of the chorus effect. Turn this control to the right to increase the speed.
8. Headphones: This is the output jack for headphones. When headphones are connected, no sound is produced from the speaker.
9. POWER Switch: This turns the power amplifier on and off. The LED lights when the power amplifier is turned on.
What are the technical specifications for the CRATE CA10 acoustic amplifier?
| Output Power | 10 watts rms @ 1.0% THD, 8 ohm load |
| Speaker | 1 x 6.5 inch, 8 ohms |
| Low | ±12 dB @ 80 Hz |
| Mid | ±12 dB @ 800 Hz |
| High | ±12 dB @ 8 kHz |
| Input Impedance | 2.2M ohm |
| Input Sensitivity | 26 mV |
| Max Input Signal | 140 mV |
| Total System Gain | 18 dB @ 1kHz |
| Dimensions | 12.6 in / 320 mm (H) 13.6 in / 345 mm (W) 10.1 in / 256 mm (D) |
| Weight | 15 lb / 6.8 kg |
| AC Power | 120 VAC / 60 Hz |
| Power Consumption | 19 watts |
What are the important safety instructions for operating the CRATE CA10?
Please read, follow, heed, and keep all instructions and warnings.
• DO NOT operate near any heat source and do not block any ventilation openings on this apparatus. For proper operation, this unit requires 3 inches (75mm) of well-ventilated space around heatsinks and other air flow provisions in the cabinet.
• DO NOT use this apparatus near splashing, falling, spraying, or standing liquids.
• CLEAN ONLY with a lint-free damp cloth and do not use cleaning agents.
• ONLY CONNECT the power cord to a polarized, safety grounded outlet wired to current electrical codes and compatible with voltage, power, and frequency requirements stated on the rear panel of the apparatus.
• PROTECT the power cord from damage due to being walked on, pinched, or strained.
• UNPLUG the apparatus during lightning storms or when unused for long periods of time.
• ONLY USE attachments, accessories, stands, or brackets specified by the manufacturer for safe operation and to avoid injury.
• WARNING: To reduce the risk of electric shock or fire, do not expose this unit to rain or moisture.
• SERVICE must be performed by qualified personnel.
• OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF THE UNIT IS OPERATED AT HIGH VOLUME.
Are there any warnings regarding liquid exposure for the CRATE CA10?
Yes. This apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
CLICK HERE TO DOWNLOAD CRATE CA10 (01) PDF DOCUMENT
