CASIO XJ-F211WN (01) PDF Document

To establish a wired LAN connection, use a LAN cable to connect the CASIO XJ-F211WN projector to a network device, such as a router. The projector can then be controlled from an external device connected to the same network.

Yes, the CASIO XJ-F211WN projector supports control using a computer web browser.

Yes, the CASIO XJ-F211WN projector supports the PJLink Class1 standard formulated by the Japan Business Machine and Information System Industries Association (JBMIA).

The following table shows the input switching instruction and input switching query parameters and their corresponding input sources for the CASIO XJ-F211WN projector.

The CASIO XJ-F211WN has the following limitations regarding PJLink commands:

• Image only mute is not supported by the AV mute instruction and AV mute state query.

• The cover open error and filter error are not supported by the error state query.

• A projector name query returns the projector name specified on the Web Service Page.

• A manufacturer name query returns CASIO.

• A device name query returns XJ-F21XN / XJ-F211WN / XJ-UT312WN / XJ-UT352WN / XJ-S400UN / XJ-S400WN.

The password used for the PJLink connection authentication process is the same as the Setup page password on the Web Service Page. You can enable or disable this authentication on the CASIO XJ-F211WN projector’s Setup Menu.

Navigate to [Network Settings] -> [Network Settings] -> [PJLINK Authentication].

• Enable: PJLink connection authentication is enabled. (This is the initial default setting).

• Disable: PJLink connection authentication is disabled.

To use a Crestron controller, you must configure the controller’s IP address and other settings on the CASIO XJ-F211WN projector. These settings are configured on the Crestron Control page, which appears when you click [Other Settings] on the Setup page on the Web Service Page.

Enter the following information:

• IP address: Specifies the controller IP address.

• IP ID: Specifies the controller IP ID.

• Port: Specifies the number of the port being used. (Always 41794).

After entering the information for each item, click the [Save changes] button to apply the new settings.

Yes, the CASIO XJ-F211WN projector supports the AMX controller and Device Discovery. The commands used for control are PJLink standard commands.

You can configure the CASIO XJ-F211WN projector to enable or disable power on via wired LAN from the standby state using the projector’s Setup Menu. Navigate to [Network Settings] -> [Remote On].

• Enable: Power on is enabled.

• Disable: Power on is disabled. (Initial default).

Note that initializing network settings with the Setup Menu will cause this setting to change to “Disabled”. If you are operating the projector using a wired LAN setting, be sure to change this setting back to “Enabled” after initialization.

The CASIO XJ-F211WN projector has the following restrictions when it is turned on from the standby state:

• The wired LAN connection will be disconnected for about one minute after the projector is turned on. During this time, even if you send a ping command, no reply is returned from the projector, and you cannot operate the projector using the PJLink / Crestron / AMX command.

• When you get an IP address from a DHCP server automatically, some DHCP servers do not always assign the same IP address. A different IP address may be assigned. If you do not want a different IP address to be assigned, change a setting to use a fixed IP address.