Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** CAMDEN DOOR CONTROLS Door Activation Devices CM-PGI, PG2, PG3 AND PG4 INSTALLATION INSTRUCTIONS 1. AN ESSENTIAL TOOL FOR: • Automatic door salespeople, and installers • Overhead door installers • Engineers, architects, and contractors • Building owners, and inspectors) 2. MEET ADA REQUIREMENTS A. The American with Disabilities Act and Canadian Regulations requires that both interior and exterior doors of a building be wheelchair accessible. B. Door Opening Force (4.13.11 ADAAG) • Exterior hinged doors: (reserved) • Interior hinged doors: 5 lbf. (22.2N) • Sliding or folding doors: 5 lbf. (22.2N) Automatic/Power Assisted Doors: (4.13.12) Such doors shall not open to back check faster than 3 seconds and shall require no more than 1 5 lbs. (66.6N) to stop door movement. Ifa power-assisted door is used, its door-opening force shall comply with 4.13.11 and its closing force shall conform to the requirements in ANSI A1 56.19 (1984). 3. OPERATING INSTRUCTIONS A. Set “o” ring on zero, down against the instruments flange, or on the desired maximum force. B. Holding the instrument firmly, either push or pull a given door at a point approximately handle-high and 30 inches toward the handle from the door’s hinges. C. Read the amount offorce required to open/close the door on the plunger scale closest to the bottom of the small “o” ring. Model: CM-PGI • 0-7 lbs. force range • This light duty gauge can be used in determining the lower limitations of interior and exterior door opening/closing forces. Model: CM-PG2 • 0-35 lbs. force range • This unit is larger and more robust. It is suitable for measuring the force of full-size, normal speed door operators as well as measuring the closing force of “overhead doors” and “elevator doors” Model: CM-PG3 • 10-50 lbs. force range • This robust unit is used to measure “door opening’ and “sliding-door” breakout panel force. Model: CM-PG4 • 10-66 lbs. force range • This robust unit is used to measure “door opening’ and “sliding-door” breakout panel force. Model: CM-PGI Model: CM-PG3 CAMDEN Opening New Doors to DOOR CONT ROLS Innovation, Quality and Support! Call: 1.877.226.3369 / 905.366.3377 Visit: wmw.camdencontrols.com Certified •SO 2008 FS 541752 Model: CM-PG2 Model: CM-PG4 File: CM-PGI to 4 Manual R2indd Revision: 07/07/2015 Part No : 40-82B044 Page 1 of 1
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL