BRAUN MULTIQUICK 5 VARIO MQ 5045 APERITIVE (01) PDF DOCUMENT

Before using your BRAUN MULTIQUICK 5 VARIO MQ 5045 APERITIVE, please observe the following safety precautions:

This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.

Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in use.

The blades are very sharp! To avoid injuries, please handle them with utmost care.

Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling or cleaning.

Do not hold the motor part (4) nor the whisk gear box (7a) under running water, nor immerse them in water.

The lids (10a, 11a) can be cleaned under running water, but do not immerse it in water, nor clean it in a dishwasher.

Before plugging into a socket, check whether your voltage corresponds to the voltage indicated on the appliance.

This appliance is designed for household use only and for processing normal household quantities.

The beaker (8) and the bowls are not microwaveproof.

The BRAUN MULTIQUICK 5 VARIO MQ 5045 APERITIVE consists of the following parts:

1. Variable speed regulator

2. Variable speed button (on/off)

3. Turbo button (T)

4. Motor part

5. Release buttons

6. Blender shaft

7a. Whisk gearbox

7b. Whisk

8. Beaker

9. 350 ml chopper «hc» (9a Lid, 9b Blade, 9c Bowl, 9d Anti-slip ring)

10. 500 ml chopper «ca» (10a Lid, 10b Blade, 10c Bowl, 10d Anti-slip ring)

11. 1250 ml chopper «bc» (11a Lid, 11b Blade, 11c Ice blade, 11d Bowl, 11e Anti-slip ring)

When activating the variable speed button (2), the processing speed corresponds to the setting of the variable speed regulator. The higher the setting, the faster the chopping results. You can adjust the speed conveniently during operation by turning the speed regulator using your thumb or index finger.

Maximum processing speed is achieved by pressing the turbo button (3). You may also use the turbo button for instant powerful pulses without having to manipulate the speed regulator.

The hand blender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing drinks and milk shakes. For best blending results use the highest speed.

1. Click the motor part (4) into the blender shaft (6).

2. Position the hand blender deep in a beaker or bowl. Then switch the appliance on.

3. After use, unplug and press the release buttons (5) to detach the motor part.

When blending directly in the saucepan while cooking, remove the pan from the stove first to avoid splashing of the boiling liquid (risk of scalding).

Use the whisk only for whipping cream, beating egg whites and mixing sponges and ready-mix desserts.

1. Insert the whisk (7b) into the whisk gear box (7a) then click the motor part (4) into the gear box.

2. Place the whisk in a bowl and only then switch the appliance on.

3. After use, unplug and press the release buttons (5) to detach the motor part. Then pull the whisk out of the gear box.

Tips for best results:

Use a medium-sized bowl.

Move the whisk clockwise, holding it slightly inclined.

For whipped cream (max. 400 ml chilled cream, min. 30% fat content, 4–8 °C): Start with low speed and increase the speed (by turning the speed regulator) while whipping.

For beaten egg whites (max. 4 eggs): Start with a medium speed and increase the speed (by turning the speed regulator) while whipping.

The choppers (9, 10, 11) are perfectly suited for chopping meat, hard cheese, onions, herbs, garlic, carrots, nuts, almonds etc. Always chop hard food at full speed (e.g. parmesan, chocolate).

Before chopping:

Pre-cut meat, cheese, onions, carrots.

Remove stems from herbs, shell nuts.

Remove bones, tendons and gristle from meat.

Always make sure that the anti-slip ring is attached to the bowl.

Operating the chopper:

1. Carefully remove the protective cover from the blade.

2. Place the blade on the centre pin of the bowl, push it down and give it a turn so that it locks.

3. Fill the chopper bowl with food and put on the lid.

4. Click the motor part onto the lid.

5. Press button (2) or (3) to operate the chopper. During processing, hold the motor part with one hand and the bowl with the other.

6. After use, unplug and press the release buttons (5) to detach the motor part.

7. Remove the lid.

8. Carefully take out the blade before removing the processed food. To remove the blade, slightly turn and pull off.

Maximum Operation Time:

For the «hc» chopper, the maximum operation time is 2 minutes for large amounts of wet ingredients, or 30 seconds for dry/hard ingredients or amounts less than 100g. Immediately stop processing when motor speed decreases and/or strong vibrations occur.

For ice crushing, use the «bc» chopper with the ice blade (11c).

1. Firmly push the ice blade (11c) onto the centre pin of the bowl (11d) until it locks.

2. Fill the bowl with up to 7 ice cubes. Put on the lid, attach the motor part and operate at full speed.

3. After use, detach the motor part, remove the lid and the ice blade.

4. Remove the crushed ice or simply pour your drink into the bowl for serving at the table.

With the «bc» chopper, you can mix batters.

First pour 375 ml milk into the bowl, then add 250 g flour and finally 2 eggs. Using speed «T», mix the batter until smooth.

Clean the motor part (4) and the whisk gear box (7a) with a damp cloth only. The lids (10a, 11a) can be cleaned under running water, but do not immerse them in water, nor clean it in a dishwasher. All other parts can be cleaned in a dishwasher.

You may remove the anti-slip rings from the chopper bowls for extra thorough cleaning.

When processing foods with a high pigment content (e.g. carrots), the plastic parts of the appliance may become discoloured. Wipe these parts with vegetable oil before cleaning them.