FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF USER GUIDE

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF USER MANUAL

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF OWNER GUIDE

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF OWNER MANUAL

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF REFERENCE GUIDE

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF INSTRUCTION GUIDE

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF REFERENCE MANUAL

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF INSTRUCTION MANUAL

FREE ENGLISH BOSCH NDP-7512-Z30 (01) PDF OPERATING INSTRUCTIONS


CLICK HERE TO DOWNLOAD BOSCH NDP-7512-Z30 (01) PDF MANUAL

If this is not the document you want for this product, click here to see if we have any other documents for this product.

How do I remove the dome cover from the camera base?

1. Press the release tab as indicated in the diagram.

2. Lift the dome cover off the camera base.


How do I install an SD card?

Insert the SD card into the designated slot inside the camera base, following the orientation shown in the diagram.

How do I reattach the dome cover to the camera base?

1. Align the dome cover with the camera base.

2. Press the cover down firmly onto the base until it clicks securely into place.


What mounting accessories are compatible with this camera for pendant mounting?

Compatible pendant mounting accessories illustrated include VGA-ROOF-MOUNT, VG4-A-9543, VG4-A-9542, VG4-A-PAX, and VG4-A-9541.

How does the camera attach to the VG4-A-9543 mount?

Align the camera’s mounting points with the corresponding connection on the VG4-A-9543 mount and join them together as shown in the diagram.

How do I connect the necessary cables to the camera?

Route the required cables through the pendant mount and connect them to the appropriate ports located inside the camera base.

How do I close the access panel on the camera base after connecting cables?

Securely close the hinged access panel located on the side of the camera base.

How do I secure the camera to the pendant mount?

Tighten the securing nut or screw that fastens the camera to the pendant mount. Apply a torque of 10-12 N-m.

How do I finish the pendant mount installation at the connection point?

Attach the final cover or cap piece to conceal the connection area at the bottom of the pendant mount pipe, as illustrated.

Where can I find software to view and configure the camera?

You can download software like BVMS Viewer, Video Security Client, and Configuration Manager from the Bosch download store at http://downloadstore.boschsecurity.com/. Scan the QR code provided in the guide for a direct link.

What product models does this guide cover?

This guide covers the BOSCH AUTODOME IP starlight 7000i (Pendant Mount), specifically models NDP-7512-Z30 and NDP-7512-Z30K.

CLICK HERE TO DOWNLOAD BOSCH NDP-7512-Z30 (01) PDF MANUAL


Leave comments, questions, reviews, tips, tricks, hacks or page errors below. Account not required.