BLAUPUNKT BC OE2 (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD BLAUPUNKT BC OE2 (01) PDF MANUAL


PDF Content Summary: REVERSE CAMERA BC OE2 Operating and Installation Instructions Installation Diagram Power Supply : DC12V±3V Current Consumption : 50mA Resolution : 750 TVL Optical Format : 1/3” Image Sensor : CMOS Effective Pixels : 960 x 576 Lens Angle : 170° (D), 120° (H) , 100° (V) Electronic Shutter : 1/60 Black Wire (Ground) Display Monitor/ Car Radio PNRDL2 Reverse Light BC OE2 Display Monitor/Car Radio Disclaimer In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages, to property or life, improper storage, whatsoever arising out of or connected with the use or misuse of our products. USA & CANADA : Product no intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased as-is. No warranty, express or implied is provided in the U.S. and Canada. Red Wire BC OE2 Ground the wire through the exterior body of the vehicle and keep connection intact. Attention ••• Remove protective film from camera lens before use. Take extra precautions when setting up the connection near petrol tank and wires. Please connect Red Wire with reverse light. SPECIFICATION •••••••• •~ 1/100000 sec •White Balance : Auto •Humidity : up to 95% •Water Proof : Yes •Illumination Min. : 0.1 Lux •TV System : PAL/NTSC •Operation Temperature : -20°C ~ +70°C • Storage Temperature : -20°C ~ +70°C 1.1 At tail light 1.2 At hatch handle 1.3 Above car plate Pictures are for illustration purpose only, see actual vehicle for accurate installation location. TROUBLESHOOTING Problem Display monitor / car radio does not show reverse view when reversing Display monitor / car radio does not show reverse view even after correcting the view setting Reverse view does not show even after restarting the display monitor/ car radio Reverse view does not show even though power supplies of the reverse light or the rear car plate light is properly connected 1. Installation Locations 2. Adjust Angle 2.0 After installation Adjust viewing angle Loosen the screws on the rotating mount & rotate the camera to the desired angle i. Remove one side ii. Connect the reverse of the reverse light light power cable to socket from its the camera, screwn housing then the housing & camera remove the bulb back into position from its socket with a screwdriver i. Use a screwdriver ii. Mount the camera to remove the where the original original hatch hatch handle used handle to be i. Remove the rotating mount before installation. Drill an access hole for the camera cables ii. Mount the camera onto the acces hole & secure it in position with 3M tape/ screws Solution Examine if the viewing mode is set to correct reverse view Restart the display monitor / car radio Examine if the power supplies of the reverse light or the rear car plate light is properly connected Examine if the power supply cables of the reverse light or the rear car plate light is damaged. Repair/replace if the cables are damaged

Designed and engineered by Blaupunkt R2 1 331 18 002 24 01


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply