FREE ENGLISH ARTEC SE-VPH (01) PDF USER GUIDE
FREE ENGLISH ARTEC SE-VPH (01) PDF USER MANUAL
FREE ENGLISH ARTEC SE-VPH (01) PDF OWNER GUIDE
FREE ENGLISH ARTEC SE-VPH (01) PDF OWNER MANUAL
FREE ENGLISH ARTEC SE-VPH (01) PDF REFERENCE GUIDE
FREE ENGLISH ARTEC SE-VPH (01) PDF INSTRUCTION GUIDE
FREE ENGLISH ARTEC SE-VPH (01) PDF REFERENCE MANUAL
FREE ENGLISH ARTEC SE-VPH (01) PDF INSTRUCTION MANUAL
FREE ENGLISH ARTEC SE-VPH (01) PDF OPERATING INSTRUCTIONS
CLICK HERE TO DOWNLOAD ARTEC SE-VPH (01) PDF MANUAL
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What are the specifications of the SE-VPH Vintage Phase Shifter?
– Battery: 9V Alkaline 6LR6l or 6F22
– DC power supply: 9V Regulated
– Power consumption: 30mA
– Frequency response: 10Hz to 20kHz
– Input impedance: 1Mohm
– Output impedance: 1kohm
– Dimension: 75.5 x 115.5 x 47.5 (mm)
– Weight: 260g (include battery)
What are the controls and connections on the pedal?
The pedal features the following controls and connections:
– Speed control
– Resonance level control (RESO)
– Depth control
– Indicator light
– DC jack (DC9V)
– Input jack
– Output jack
– Foot switch
What does it mean if the indicator light is blinking or off?
If you use a battery, and the indicator goes blinking or no longer lights up while an effect is on, it means that the battery is nearly dead and must be replaced. If you are using a power supply system, it means that the voltage of the power supply is too low or it is disconnected.
What kind of battery and power supply should be used?
Battery: When using the pedal with batteries, please use ALKALINE batteries to prevent leaking damage.
Power Supply: When using the pedal with an AC adaptor or DC power supply system, please use a DC9V REGULATED (100mA or higher) power supply. Using an unregulated or switching power for an IT system can cause HUM NOISE of high frequency.
Is there a warning about the rubber feet on the pedal?
Yes. The plasticiser contained in the rubber feet of this product may possibly react with the coating of your parquet, linoleum, laminate or PVC floor and after some time cause permanent dark stains. In case of doubt, do not put the rubber feet directly on the floor, but use felt-pad floor protectors or a carpet.
How should I dispose of the product and its packaging?
Packaging: For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the notes and markings on the packaging.
Product: This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its currently valid version. Do not dispose of your old device with your normal household waste. Dispose of this product through an approved waste disposal firm or through your local waste facility. Comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility.
CLICK HERE TO DOWNLOAD ARTEC SE-VPH (01) PDF MANUAL