ARIETE 2358 (01) PDF MANUAL

The appliance includes the following components:

A: ON/OFF button

B: Power cord

C: Handle

D: Hepa filter

E: Plastic filter

F: Plastic filter handle

G: Bristle roller locking door

H: Bristle roller locking/unlocking screw

I: Wall mount

J: Wall plugs (x 3)

K: Screws (x 3)

L: Multifunctional brush

M: Nozzle

N: Bristles button

O: 2-in-1 brush

P: Motorized brush with bristle roller

Q: Brush release button

R: Tube

S: Motor body release button

T: Dust collector release button

U: Dust container

V: Motor body

Please read these warnings carefully:

Intended Use:

The appliance is designed for household purposes or similar, such as in cooking areas for staff, offices, farms, hotels, and other residential facilities. Do not use the appliance for any other purposes. It is designed for vacuuming dust from surfaces. It is forbidden to vacuum hot ashes, liquids, large pieces of glass, rubbles, or sharp/pointed objects.

Electrical Safety:

Before plugging in, check that the voltage on the rating plate matches your local supply. Always connect to an earthed socket. Do not use unauthorized extension cords. Do not immerse the appliance, plug, or power cord in water. Do not use with wet hands or barefoot. Do not leave the appliance unattended while connected. Do not pull the power cord to disconnect.

General Safety:

Do not use the appliance outdoors or expose it to weather. Do not place it on or near hot surfaces, open flames, or stoves. Do not use without filters, or if filters are broken or damaged. Do not use the motorized brush without the bristle roller. The appliance cannot stand on the brush in a vertical position on its own. Do not turn the appliance upside down during use, as dirt and dust can escape.

Child Safety:

The appliance can be used by children over 8 years old if supervised. Always keep the appliance and power cord out of the reach of children under 8. Children shall not play with the appliance. Cleaning by children is only permitted if they are over 8 and supervised.

To prevent damage, do not vacuum the following:

Hot ashes, liquids, large pieces of glass, rubbles, or sharp/pointed objects.

Very hot, smoking, or burning objects such as cigarettes, matches, or ashes.

Flammable or combustible materials (e.g., gasoline, kerosene) or use in the presence of water.

Toxic materials (e.g., chlorine bleach, ammonia, drain cleaner, acids).

Do not use in closed environments with fumes from oil-based paints, solvents, or flammable/toxic/explosive fumes.

First, install the wall mount (I) in a dry and safe place, keeping the appliance out of the reach of children.

To use the appliance, press the power button (A). The appliance will start operating at maximum power.

After use, fasten the appliance on the wall mount.

If something gets trapped in the brush (e.g., cloth, carpet fringe), turn the appliance off immediately. Remove the dirt from the brush before turning it on again.

The appliance comes with various accessories for different cleaning tasks:

Motorized brush with bristle roller (P): Particularly suitable for deep cleaning of rugs, carpets, and floors.

2-in-1 brush (O): Ideal for cleaning floors of all kinds, carpets, and rugs.

Multifunctional brush (L): Suitable for vacuuming dirt from fabrics, sofas, and horizontal surfaces.

Crevice nozzle (M): Suitable for vacuuming in hidden corners and narrow slots.

Accessories can be attached to the tube (R) to reach high points or directly to the motor body (V) for cleaning windows or car interiors.

To use the 2-in-1 brush (O):

Press the bristles button (N) to release the bristles from the brush for cleaning hard surfaces like floors.

Press the bristles button (N) again to retract the bristles into the brush for cleaning soft surfaces like carpets.

Always unplug the appliance before cleaning. The aspired dirt enters the dust container (U). The air is first filtered by the plastic filter (E) and then the HEPA filter (D). Both are located inside the dust container.

1. Press the dust collector release button (T) and pull the dust container upwards to separate it from the motor body.

2. Remove the Hepa filter (D) from the dust container.

3. Clean the Hepa filter with a brush with long and soft bristles. Do not wash the Hepa filter with water, as it could lose its filtering capacity.

4. Hold the dust container (U) over a trash bin.

5. Grab the plastic filter handle (F) and remove the plastic filter (E) from the dust container.

6. Empty the dust into the trash bin.

7. Wash the plastic filter (E) under running water without using soaps or detergents.

8. Insert the plastic filter only after it is completely dry. It is recommended to let it dry naturally for at least 24 hours.

9. Insert the clean plastic filter back into the dust container.

10. Insert the clean Hepa filter back into the dust container.

11. Place the joint on the dust container near that of the motor body and lower the container to fasten the two parts. A “click” sound confirms correct insertion.

It is recommended to change the Hepa filter every 4-6 months to avoid the circulation of bacteria in the air.

1. Remove the 2-in-1 brush (O) from the tube.

2. Turn the brush upside down.

3. Clean the bristles from the dirt.

Do not lubricate or grease the rotating parts. The bristle roller can be removed for cleaning.

To remove the bristle roller:

1. Press the brush release button (Q) to remove the motorized brush from the tube.

2. Turn the motorized brush upside down.

3. Turn the bristle roller locking/unlocking screw (H) to the unlock symbol to unlock the bristle roller.

4. Lift the bristle roller locking door (G).

5. Remove the bristle roller from the side of the locking/unlocking screw.

6. Clean the bristles from the dirt.

To reassemble the bristle roller:

1. Insert the side opposite the bristle roller locking door first. A “click” sound indicates correct insertion.

2. Lower the bristle roller locking door (G).

3. Turn the bristle roller locking/unlocking screw (H) to the lock symbol to lock the bristle roller.

In the case of decommissioning, the appliance must be electrically disconnected. Empty the dust container. If the appliance is to be disposed of, separate the various materials used in its construction and dispose of them according to their composition and the legal provisions in your country of use.