ANKO BY-655 (01) PDF Document

Use this appliance to straighten human hair only. Do not use this appliance on artificial hair or animals. The appliance may have different results depending on the hair type. Therefore, it is recommended to do a trial at a hidden spot before first use. The hair straightener is not recommended for damaged or bleached hair.

After unpacking the appliance, check for transport damage and that all parts are present. Clean the appliance as described in the Cleaning and Maintenance instructions. Fully unwind the cord before use.

1) Heat plates

2) Temperature Up

3) Temperature Down

4) On/Off switch

5) LED display

6) Plate lock

Fully unwind the supply cord.

Place the appliance on a smooth, flat, dry surface.

Connect the power plug to a mains power outlet socket. The display will show “OFF”.

Press and hold the ON/OFF switch and the LCD display will illuminate.

Use temperature setting buttons (2)/(3) to increase “+” or decrease “-” the plate temperature. Set the desired temperature in a range between 110°C and 230°C.

The temperature bar will keep flashing while heating up. The bar is steady when the device has reached the temperature you had set.

The heating plates heat up very fast. It takes approx. 3 minutes to reach max. temperature. Note that the heating plates cool down slower than they heat up.

When the appliance is ready, you may start hair styling.

To begin straightening hair, take a section no more than 4 to 5cm wide. Place the hair between the two flat plates, as close as you can near the scalp.

Hold the plates tight for a couple of seconds and slide the straightener in an even motion towards the ends. For best results, hold the hair while smoothing the section.

Do not hold the hair between the plates for more than a couple of seconds as this may damage your hair.

When you have finished one section, move to another area of hair and repeat the process. Allow the hair to cool before combing through.

After using, turn OFF the appliance. Make sure the power indicator has gone off. Unplug the appliance, and put it on a table to allow for cooling.

Turn off the appliance before cleaning and disconnect the plug from the power outlet.

Do not clean the appliance while it is still hot. Risk of burning!

Wipe the appliance with a dry cloth.

Never submerge the appliance in water or let water run over the heating plates or appliance.

The heating plates can be cleaned with a slightly damp cloth and a little detergent if necessary. Dry thoroughly after cleaning.

Do not use any alcohol, acetone, gasoline, or abrasive cleaning agents to clean the plastic components. Do not use hard brushes or metal objects for cleaning.

Store the appliance in a cool, dry location, away from children and pets.

If the appliance is not used for an extended period, store it preferably in its original packaging.

After use, do not wrap the cord around the appliance as in time this may cause the cord to fracture. Coil cord loosely by the side of the appliance in storage.

Allow to cool before putting it down or storing away.

Do not use this appliance near bathtubs, showers, basins, or other vessels containing water.

To protect against electric shock, do not immerse the power cord, plug, or appliance in water or any other liquid.

When the appliance is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the appliance is switched off.

NEVER grasp the appliance, power cable, or power plug with wet hands.

If the supply cord is damaged, Do NOT USE. Any repairs to the product must be carried out by qualified electrical person only or the product must be disposed.

Model: BY-655

Voltage: 220-240V~ 50-60Hz

Power: 130W