ANKO 42949244 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD ANKO 42949244 (01) PDF MANUAL


PDF Content Summary: BLUETOOTH PARTY SPEAKER 42949244

Contents Warning 1 Important precautions 1 Package contents 2 Description of rear panel 3 Description of Remote Control 4 Warning The lighting flash with arrowhead symbol, with an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be sufficient magnitude to constitute a risk ofelectric shock topersons. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERICEALBE PARTS INSIDE REFEER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended alert the user tithe presence of important operating and maintenance (servicing) instructions in the l iterature accompanying the appliance.

Getting Started 5 Function Instructions 6 Connect Wired Microphone and Guitar 8 Warranty 9 Important precautions: 1. The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, suchas vases, shall be placed on the apparatus. 2. Minimum distances 100 cm around the apparatus for sufficient ventilation. 3. The ventilation should not be impeded by covering the ventilation opening swith items, such as news papers, table-cloths or curtains. 4. No naked flame sources such as lighted candles,should be placed on the apparatus. 5. When the mainsplug or and appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 6. To be completely disconnected the power input, the mains plug of apparatus shall be disconnected from the mainscom pletely. 7. The main plug of apparatus should not be obstructed or should be easily accessed during intended use. 8. The use of apparatus in moderate climates. 9. Attention should be drawn to the environmental aspects of battery disposal. 10. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. 11. Excessive sound pressure from earphones and headphones can cause hearing loss. 12. The internal battery is non-user replaceable. 13. Do not use this apparatus near the water.

1

Package contents 1.Speaker x 1 2.Remote control x 1 3.AC power cable x 1 4.User manual x 1 5.AUX in Cable x 1 Product specications Speaker Power Supply : 220-240V~ 50Hz FM Radio : 87.5-108MHz DESCRIPTION OF REAR PANEL 8 910 11 12 12 13 3 14 4 15 5 16 6 17 18 19 20 7 21 22 23 24 25 26 1.Previous Button 2.REC Button 3.MODE Button 4.Power Button Speaker : 12 Inch * 2 + Treble Battery : 12V 7Ah Line In : 3.5mm Microphone Input : 6.35mm DC Input(external) : 12V 5.Charge RED Battery Indicator 6.DC 12V 5A Input 7.AC Input 8.LED ON/OFF Button 9.Volume Knob 10.Next Button 11.Treble Knob 12.Bass Knob 13.Audio Output Jack 14.AUX Input Jack 15.Play/Pause Button 16.PRI (Priority) Button 17.USB Input Slot 18.TF Card Slot 19.MIC Volume Knob 20.MIC Echo Knob 21.MIC Dleay Knob 22.MIC Treble Knob 23.MIC Bass Knob 24.Guitar Knob 25.Microphone 6.35mm Input Jack 26.Guitar 6.35mm Input Jack

2 3

DESCRIPTION OF REMOTE CONTROL 1. Power on/off 2. Mode 3. Mute 4. Volume+ 5. Previous Track/CH 6. Scan 7. 0-9 keys 8. EQ Function 9. Play/Pause 10. Next Track/CH+ 11. Volume - 12. Repeat 1 2 3 To insert the remote control batteries: 1.Open the battery compartment. 2.Insert 2 x AAA batteries with correct polarity (+/-) as indicated. The 2xAAA battery not include in our products. 3.Close the battery compartment. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Getting Started Connecting Power Cable Warning:Ensure the AC/Charge switch is in OFF position before plugin.Plugin the AC connector into the 220-240V 50Hz inlet socket in the rear panel of the unit and the other end into the standard AC 240V wall socket. 1. Do not plug or unplug the power cable while you have wet hands. 2. To protect this apparatus from alightning storm, or when left unattended and unused for long periods of time, unplug power cable from the wall outlet. 3. When unplugging the power cord from a wall outlet, always pull on the power plug only. Never unplug it by pulling the power cord. Charging the internal Battery The speaker comes with a built-in rechargeable battery, follow the below steps to charge it: AC INPUT(220-240V) Charging 1. Please connect the power cable on the rear panel and plugin to the 220-240V 50Hz wall socket to charge the speaker. 2.When start charging, the RED LED indicator will light on. 3.When almost full charging, the RED LED indicator will keep flashing. 4.When full charge, the RED LED indicator light will light off. DC 12V IN Charging Connect the DC cable of the external power supply to the DC 12V IN terminals of the speaker rear panel, please corresponding connect to the Red (+) and Black (-) indicated. Noted: This DC input not for the battery charging, only supply the power to work for the speaker. Note:please fully charge the product when it is not going to be used for a long time and charge once a month to keep longer battery life. Turning ON/OFF the speaker 1.Press Power ON/OFF button on the rear panel to turn on or off the speaker. 2.Use the remote control to turn it into Standby mode, press it again to power it on. Intrenal Battery Level indicator 1.There are three grids battery indicator symbol keeping static on the right bottom corner of the display screen, meaning battery capacity is full. 2.As the battery capacity less, the battery indicator symbol will become as two grids. 3.When the rest one grid battery indicator and keeping flashing,meaning the battery capacity is almost running out, please charge the battery on time, otherwise the speaker will turn off. Note: There is the low battery warning sound "DI DI" per 10 seconds when the battery capacity run out as above 3.

4 5

Function Instructions USB Operation This unit has a USB port for play back MP3 music. · Insert your USB device into the USB port and the unit will start playing automatically. Press the [MODE] button to USB mode is selected. · Press the or key to the previous or next track. · Press the button to play or pause music · Press button on the remote to repeat the current track, press it again to repeat all tracks. FM Operation This speaker supports FM radio function. 1.This speaker has built-in antenna, no need to insert FM antenna. 2.Press [ MODE ] button on the rear panel or on the remote control repeatedly until FM function is selected. 3.Short press button on the top panel to search the FM radio station automatically. 4.Press or to select the previous or next FM radio station. Bluetooth function 1.Press [ MODE ] button on the top panel switch to the Bluetooth mode if the speaker on other mode, there is a prompt sound. 2.Once on the Bluetooth mode," bLUE " will keep flashing on the display screen. 3.Open the Bluetooth funciton of the external device and search the Bluetooth device name "42949244 " to pair. 4.Press connect to "PAIR" with the speaker. 5.Once connected, " bLUE " will keep static on the display screen and can hear a prompt sound, you can play the music with the speaker. 6.You can use button or button on the rear panel or on the remote to control the songs of the external device. TWS Connecting This speaker supports TWS pairing function, please buy two same speaker to enjoy this function. 1.Turn on the Bluetooth function of the one speaker, connected the bluetooth and playing music. 2.Long press MODE button on the rear function panel to open the TWS function, " " will short display on the screen. 3.Turn on the bluetooth of another speaker and " bLUE " will keep flashing on the screen, then long press [ MODE ] button of this speaker to open the TWS function, " " will short display on the screen and "bLUE " will keep static. 4.Both speakers' TWS will pair automatically if above operation correct. Once TWS paired successully, " bLUE " of both speaker will keep static. 5.Turn the volume knob on the function panel of any speaker increase or decrease the music volume. 6.If not using the TWS function, please long press [ MODE ] to deconnected TWS, " " will short show on the display screen, and " bLUE " will keep flashing on another speaker. Function Instructions Connect with AUX in 1.Press [ MODE ] button on the rear function panel to switch to the Line in mode," AUH " will be displayed on the screen. 2.Connect this speaker Line in input jack and the device Earphone jack by provided Line in cable (supplied in the accessories) 3.Once connected,turn on your external device and play music. Caution: Please turn off the unit before connect AUX cable in order to avoiding unexpected noise. Microphone REC Function 1.Before recording, please make sure the speaker insert a USB driver to save the record file. 2.When playing music, insert the microphone and long press REC button on the top panel to turn on the recording function and the display will show “ “, then the speaker will record the sound from the microhone to USB driver, you can speak any words or sing. 3.Short press REC button to stop the recoding and the recorded sound from the USB driver. 4.Short press REC button again can withdraw the playing record mode and back to USB playing mode. Note:Recording function only record the voice from microphone input. Bluetooth and AUX input are not recorded. PRI(Priority) Function 1.When playing music, long press PRI button on the top panel to turn on the weakening of human vocal from the music , the display will show " " 2.Long press PRI button again to turn off the weakening of human vocal from the music , the display will show " " 3.Short press PRI button on the top panel to turn on the microphone priority function, the display will show " " 3.Short press PRI button on the top panel to turn off the microphone priority function, the display will show " ”

6 7

Connect with Wired Microphone and Guitar Connect to Wired Microphone and Guitar Insert 6.35mm wired microphone, and use control knob to adjust the sound level. When playing with the wired microphone, please use these knobs to adjust the sound volume/ echo volume/ delay volume/ treble volume/ bass volume of microphone. When insert the Guitar, please use the guitar volume to adjust the sound volume. Important Notes While using the microphone, avoid being put the microphone opposite the bass of Party Speaker,as they may have Whistler Noisy. To get the best singing performance, keep the micro phone within 5-15cm of the mouth and at a 45 degree angle. When using the microphone, always pay attention to the battery. If the battery is low, the indicator light will come on and the performance will progressively become poor. Caution: Please do not put the microphone directly face to the Party speaker, it may damage the speaker. Warranty

8 9


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply