ANKER NEBULA SOLAR D2130 (01) PDF Document

To set up the ANKER NEBULA SOLAR D2130, place the projector on a flat, stable surface. You can open the projector nameplate as illustrated in the manual to use it as a stand for better positioning.

To prepare the remote control for the ANKER NEBULA SOLAR D2130, follow these steps:

1. Slide down the battery compartment cover to open it.

2. Insert two new batteries, ensuring you match the polarity (+ / -) as indicated inside the compartment.

3. Slide the cover back into place.

The power instructions for the ANKER NEBULA SOLAR D2130 depend on the specific version of the hardware:

For the Nebula Solar: Press the power button once to power on.

For the Nebula Solar Portable: Press and hold the power button for 2 seconds to power on.

To power off: Press and hold the power button. A menu will appear on the screen; select Power Off to turn off the projector. When the projector is in standby mode, you can press the power button to turn the projector on or off.

To adjust the focus of the ANKER NEBULA SOLAR D2130, press the specific focus button located on the remote control. This button is identified by a square icon with a circle inside. Pressing this button will allow the projector to adjust its focus for a clear image.

The remote control for the ANKER NEBULA SOLAR D2130 includes the following buttons and functions:

Power On / Off: Turns the projector on or off.

Google Assistant: Press to activate the Google Assistant voice control.

Navigation: Used to navigate through menus and content.

Confirm: Used to select or confirm the highlighted content.

Home: Returns the interface to the home screen.

Back: Returns to the previous screen.

System Settings: Opens the projector’s system settings menu.

Volume Up / Down: Adjusts the audio output levels.

Focus: Adjusts the image clarity.

To wirelessly cast movies, games, and music from your phone to the ANKER NEBULA SOLAR D2130:

1. Ensure your phone and the ANKER NEBULA SOLAR D2130 are connected to the same wireless network.

2. Play a video clip on your phone and tap the cast icon on the video screen.

3. Select the ANKER NEBULA SOLAR D2130 from the list of available devices to mirror your phone screen to the projector.

No, the HDMI port and the USB port on the ANKER NEBULA SOLAR D2130 cannot be used to simultaneously stream video and audio content.

The ANKER NEBULA SOLAR D2130 uses the following power specifications based on the model type:

Note: The plug of the adapter is considered the disconnect device. Once unplugged, the charger is disconnected from the power source.

Follow these safety guidelines when using the ANKER NEBULA SOLAR D2130:

Due to the enclosure material, the product must only be connected to a USB 2.0 or higher interface.

The adapter should be installed near the equipment and must be easily accessible.

Do not use the device in an environment where the temperature is too high or too low. Never expose the device to strong sunshine or wet environments.

The ideal temperature range for this product and its accessories is 41 degrees Fahrenheit to 95 degrees Fahrenheit (5 degrees Celsius to 35 degrees Celsius).

When charging, place the device in an environment with a normal room temperature and good ventilation. The charging temperature range is 41 degrees Fahrenheit to 77 degrees Fahrenheit (5 degrees Celsius to 25 degrees Celsius).

Only use the charger provided by the manufacturer. Using unauthorized chargers may cause danger and violate the authorization of the projector.

This charger is for indoor use only.

Possibly hazardous optical radiation may be emitted from this product; do not stare at the operating lamp as it may be harmful to the eyes.