AMBIENT WM-4 (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD AMBIENT WM-4 (01) PDF MANUAL


PDF Content Summary: Ambient Weather WM-4 User Instruction Manual (Ver. 1.0) Wind Impeller Wind Vane Units SET/ EL & 300)Mode/ On/ Off Tripod Fitting Getting Started Open your WM-4 to 180oas shown. If using a tripod, open your WM-4 to a 90o angle as shown above to access the tripod fitting. To turn the unit on or off, press and hold Mode key for about 3 sec. You can turn off the unit at any mode. If the unit is idle for 5 minutes, it will auto shut down to preserve battery life. When taking wind measurements by hand, make sure to keep the WM-4 at arm’s length from the body with the display facing towards you so the wind will enter the wind impeller through the rear. Use the wind vane to orient the wind meter so you are on the wind’s axis. This will give you the most accurate measurement. CAUTION: The WM-4 is very accurate at low and mid-range air speeds. Consistent use at very high speeds, such as from a fast-moving car, will damage the impeller’s bearing and reduce its accuracy. See below for impeller replacement. Using the wind meter functions When the unit is turned on for the first time, the default mode is wind speed. Going to other modes or features is simply done by pressing the Mode button. Pressing Units Key at any mode (except Compass and Humidity) changes the unit to your preferred measurement unit. Units of measurement sequence is shown below for each model. Mode Sequence Press the Mode button to sequence the following parameters: ∙ Wind Speed ∙ Max Wind Speed ∙ Avg. Wind Speed ∙ Compass ∙ Temperature ∙ Wind Chill ∙ Humidity ∙ Wet Bulb Temperature ∙ Comfort Index ∙ Delta T Units Sequence Select the Units button to display the parameter you wish to sequence units: Current, Max, Avg. Windspeed: Mph->Kmph->mps->fpm->Beaufort Scale->Knots Sequence for WM 200 ∙ Wind speed – displays real time wind speed ∙ Max. wind speed – displays max. wind speed ∙ Avg. wind speed – displays 10-sec average ∙ Compass ∙ Temperature ∙ WindChill Max. / Avg. / Wind Speed MPH---->KMPH---->MPS---->FPM---->BF---->KNT Temp. / Wind Chill 0F---->0C Sequence for WM 300 ∙ Wind speed – displays real time wind speed ∙ Max. wind speed – displays the max. wind speed ∙ Avg. wind speed – displays 10-sec average ∙ Compass ∙ Temperature ∙ WindChill ∙ Humidity (Sensor is self-calibrating) ∙ Wet Bulb ∙ Dewpoint ∙ Comfort Index ∙ Delta Temperature

1 2 3 4

Temperature, Wind Chill, Wet Bulb, Comfort Index, Delta T: Digital Wind Direction Setting the Comfort Index™ Key Function Matrix Warranty

∙°F->°C Compass Calibration Point the WM-4 directly into the wind and select Compass mode. The edge of the wind vane will point directly towards Accuweather.com® Comfort Index™ is the effect of temp, relative humidity, wind speed & sun intensity on the human body. You can adjust the formula based on sun intensity. ModeKeys Mode/ On/ Off SET/ EL Units Wind speedChange mode (Hold to turn power ON/ OFF)--------------- Change Units Ambient, LLC provides a 2-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is

If necessary, to correct for the presence of ferrous metals, the compass can be calibrated. you. Wind direction is displayed digitally and in compass points. The solar factor has a range of 0 to 3.0 with a default setting of 1.5 (medium sun intensity). Example: Full sun = 3.0; Heavy clouds = 0. To change, press and hold SET/EL key. Max. Wind speed Avg. Wind speed Change mode (Hold to turn power ON/ OFF)--------------- Change Units Change mode (Hold to turn power ON/ OFF)--------------- Change Units valid only on products purchased and only to the original purchaser of this product. To receive warranty service, the purchaser must contact Ambient, LLC for problem determination

Go to compass mode press and hold SET/EL The compass feature can also compute the cross and Press Units key to adjust the current value of the solar factor and press SET/EL to confirm and exit the setting CompassChange mode (Hold to turn power ON/ OFF) Hold to enter Compass Calibration Hold to mark direction and service procedures.

key till display shows “COMPASS CAL” (blinking). Turn the unit in a vertical position as shown. Turn the unit around twice, 15 sec per turn, as shown. After completing the 2 turns press SET/EL key to confirm calibration. If the display shows “END” the calibration is successful. If the display shows “ERR” redo the calibration process. head/tail wind. Point the meter in the direction of travel or target and get a steady compass reading. Press and hold Units key until MARK stops blinking. Release Units key and point the meter into the wind until you have a steady compass reading. Press and hold Units key until MARK stops blinking. The meter will display cross wind and to view head wind press the Units Key. The computed cross and head/tail wind may indicate a minus (–) sign. The minus (–) sign will indicate the wind is coming from the back, while no sign will indicate that the wind is coming from the front. To mode. Replacing the Battery (All models) The unit uses a CR2032 Lithium battery. Turn the unit to the back. Use a coin to turn battery cover as indicated by the arrow. Insert the battery with the printed side facing you and close the battery door. Changing the Wind Impeller (All models) WM-4 impellers can be replaced. Contact Crosswind Exit to compassHold to enter Compass CalibrationHeadwind Headwind Exit to compassHold to enter Compass CalibrationCrosswind Compass Calibration--------------- Exit to compass --------------- TemperatureChange mode (Hold to turn power ON/ OFF)--------------- Change Units Wind ChillChange mode (Hold to turn power ON/ OFF)--------------- Change Units HumidityChange mode (Hold to turn power ON/ OFF)--------------- --------------- Wet BulbChange mode (Hold to turn power ON/ OFF) ----Change Units Dew PointChange mode (Hold to turn power ON/ OFF)--------------- Change Units Warranty service can only be performed by a Ambient, LLC. The original dated bill of sale must be presented upon request as proof of purchase to Ambient, LLC. Your Ambient, LLC warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (lack of reasonable and necessary maintenance); (2) damage resulting from failure to follow instructions contained in your owner’s manual; (3) damage resulting from the performance of repairs or alterations by someone other than an authorized Ambient, LLC authorized service center; (4) applications and uses that this product was not intended.

exit, press Mode. AmbientWeather.com for parts and instructions. Your instrument has a 2-year warranty. Please save your Comfort IndexChange mode (Hold to turn power ON/ OFF) Solar Factor Hold to enter Solar Factor SettingChange Units This warranty covers only actual defects within the product itself,

invoice for verification and contact AmbientWeather.com for questions or service: 877-413-8800, 8am-4pm M-F (Arizona Time) website: ambientweather.com email: support@ambientweather.com Setting--------------- Exit to Comfort Index Advance adjust Delta TChange mode (Hold to turn power ON/ OFF)--------------- Change Units and does not cover claims based on misrepresentation by the seller or performance variations resulting from installation-related circumstances.

5 6 7 8 9 9


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply