AFERIY NANO100 AF-PB010 (01) PDF Document

The packing list for the AFERIY NANO100 AF-PB010 includes:

• The AFERIY NANO100 AF-PB010 Product

• A USB-C female to DC7909 female Adapter

• The User Manual

The AFERIY NANO100 AF-PB010 features the following components and ports:

• LCD Display

• Display screen buttons

• USB-C(M) 100W Input/Output port (retractable cable)

• USB-A(F) 18W Output port

• USB-C(F) 45W Input/Output port

The display button on the AFERIY NANO100 AF-PB010 controls the turning on and off of the display. After the device is on, long-pressing the button for 3 seconds will put it into sleep mode.

To activate the ‘Always-On Mode’ on your AFERIY NANO100 AF-PB010, press the display button ten times consecutively. The “%” icon on the display will blink continuously at a rate of once per second to indicate the mode is active.

To deactivate the ‘Always-On Mode’, press the display button ten times consecutively again. The “%” icon will return to normal.

The display interface of the AFERIY NANO100 AF-PB010 shows the following information:

1. Input power

2. Recharging Time

3. Battery Progress Bar

4. Output power

5. Output remaining time

6. Battery Level Percentage

The fault codes on the AFERIY NANO100 AF-PB010 display indicate specific protection modes or errors:

The “Display” button controls turning the display on and off. If the AFERIY NANO100 AF-PB010 is not being charged or connected to another load, the display will automatically turn off after 3 minutes. The product can be charged directly or connected to a load for discharging without needing to press the “Display” button.

There are two methods to charge your AFERIY NANO100 AF-PB010 from a mains power source (note: a charger is not included in the packing list):

Method 1: Plug a charger into the mains power. The power station can be directly charged through the port of the accompanying retractable USB-C (M) cable. The maximum charging power can reach PD100W, depending on the charger and the product’s current charge level.

Method 2: Plug a charger into the mains power. The power station can be directly charged by connecting a data charging cable (not included) to the USB-C (F) port. The maximum charging power can reach PD45W, depending on the charger, data cable, and the product’s current charge level.

You can charge the AFERIY NANO100 AF-PB010 with a compatible solar panel using one of the following methods:

With an AFERIY AF-SL030 mini Solar Panel: If you have purchased the AFERIY AF-SL030 solar panel (30W max), you can directly plug the USB-C (M) port of the power station’s retractable cable into the USB-C port of the solar panel. The maximum output power of the AF-SL030’s USB-C port is PD18W.

With a Solar Panel with an MC4 Interface: If you have a solar panel with MC4 interfaces (voltage range 12V – 26V), you will need to purchase an MC4 to DC7909 male adapter cable. Use the included DC7909 female to USB-C female adapter to connect the power station’s retractable USB-C (M) cable for charging. The maximum charging power can reach 100W, depending on the solar panel’s specifications, lighting conditions, and the product’s current charge level.

You can charge your AFERIY NANO100 AF-PB010 in a car using one of two methods:

Method 1: Once the car ignition system is on, connect the USB-C (M) port of the retractable cable to a car charger (not included). The maximum charging power can reach 100W, depending on the power of the car charger and the product’s current charge level.

Method 2: Use a cigarette lighter to DC7909 male adapter cable (purchased separately). Connect this to the included DC7909 female to USB-C female adapter, and then connect the USB-C (M) port of the retractable cable. The maximum charging power can reach 60W.

For safety, this product can only be charged through a 12V car charger port. Please start charging only after the car ignition to avoid car battery power loss. Ensure the car charger port and charger are in good contact and the cigarette lighter is fully inserted. Do not charge while driving on bumpy roads to prevent poor contact which could cause the contact point to burn out.

Please observe the following precautions when charging your AFERIY NANO100 AF-PB010:

• Solar charging or car charging can only be done through the USB-C (M) 100W port, not the USB-C (F) 45W port.

• Solar charging only supports a voltage range of 12V ~ 26V. Exceeding this voltage will damage the product.

• Car charging only supports 12V models and is not intended for 24V models, which will damage the product.

• This product is not intended for simultaneous charging through the USB-C (M) and USB-C (F) ports.

• The USB-A(F) and USB-C(F) ports share the same circuit and cannot be used for charging and discharging simultaneously.

The technical parameters for the AFERIY NANO100 AF-PB010 are as follows:

General Specifications:

Input Specifications:

Output Specifications:

When using the AFERIY NANO100 AF-PB010, basic safety precautions should always be followed:

1. Please fully charge this product for first use.

2. Store this product in a cool and dry place, do not store this product in high temperature or humidity. The operating temperature shall be 0 °C ~ 40 °C (32 °F ~ 104 °F).

3. Please use a safety-certified charger to charge this product; otherwise, it may cause fire hazards or personal injury.

4. This product may heat up while charging, which is normal and needs no worry.

5. When this product is idled, please disconnect the power plug from the socket.

6. Do not disassemble this product. In the case of maintenance, seek a qualified repairman. Improper reassembly may cause fire hazards or personal injury.

7. Do not expose this product to rain or snow, nor allow water intrusion. It is forbidden to use the product after immersion in water.

8. Do not use damaged or modified battery packs, which may bring about unpredictable results, such as fire hazards, explosion, or risk of injury.

9. Do not expose this product pack to fire or heat. Exposure to fire or temperatures above 100 °C may cause an explosion.

10. No use or place in high temperatures (such as in sun hot or burning-hot cars); otherwise, it may cause overheat of the internal battery, fire hazards or functional failure, and shortened service life, and etc.

11. The battery may explode at extremely low air pressure.

12. It is forbidden to use damaged wires or plugs, or damaged charging cables for output, as there is a risk of electric shock.

13. If this product is idled for a long time (3 ~ 6 months) after battery depletion, its performance will decline and even to the extent of inability to be charged.

14. If the product is to be idled for a long time, be sure to charge and discharge it every 3 months and keep the final electric quantity at about 60% to 80%.

15. Do not use harmful chemicals or detergents to clean this product.

16. Improper use, falling off or excessive force may cause damage to this product.

17. Pay close attention when children are close to the product in use, so as to reduce the risk of personal injury.