Free English ADLER AD 7752 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD ADLER AD 7752 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the electrical requirements for the ADLER AD 7752?
The ADLER AD 7752 should only be connected to a 220-240V ~ 50/60 Hz grounded outlet.
How do I set the temperature on the ADLER AD 7752?
The temperature setting range is 5-50 degrees Celsius. To set the temperature, press the Plus button (E) or the Minus button (F). The digital display (G) will flash, and the temperature will increase or decrease by 1 degree Celsius after each press. If no action is taken, the setting will be saved in 3 seconds. After setting, the display will show the room temperature.
What are the heating power settings for the ADLER AD 7752?
You can adjust the heating power by pressing the Heating mode button (B) on the ADLER AD 7752:
Once: Sets low heating power (800W) and “01” is shown on the digital display (G).
Twice: Sets medium heating power (1200W) and “02” is shown on the digital display (G).
Third time: Sets highest heating power (2000W) and “03” is shown on the digital display (G).
Fourth time: Returns to the low heating power (800W).
How does the timer function work on the ADLER AD 7752?
The ADLER AD 7752 has two timer functions:
Delayed turn-off: While the device is on, press the upper Timer button (C). The digital display (G) will flash. Press the Plus (E) or Minus (F) button to set the period after which the device will automatically turn off. The timer increases or decreases by 1 hour per press.
Delayed turn-on: While the device is in standby mode, press the lower Timer button (D). The digital display (G) will flash. Press the Plus (E) or Minus (F) button to set the time after which the device will automatically turn on.
What is the anti-frost function on the ADLER AD 7752?
If the ADLER AD 7752 is in standby mode and the room temperature drops below 5 degrees Celsius, the heater will automatically start heating and display the Frost protection icon (J). It will stop heating once the room temperature reaches 10 degrees Celsius.
What should I do if the ADLER AD 7752 displays E2?
If the ADLER AD 7752 displays “E2”, it indicates a temperature sensor fault. In this case, the device requires professional repair.
How do I clean the ADLER AD 7752?
The ADLER AD 7752 should be cleaned at least once a month during the heating season:
1. Always unplug the device and ensure it has cooled down before cleaning.
2. The heater should never be immersed in water. Wipe the housing regularly with a damp cloth and dry the surface thoroughly before turning it on again.
3. Do not use aggressive detergents (emulsions, lotions, pastes, etc.) for cleaning, as these may remove information graphic symbols or warning signs.
What are the technical specifications of the ADLER AD 7752?
The ADLER AD 7752 has the following technical specifications:
| Voltage | 230V ~50Hz |
| Power | 2000W |
| Standby mode power | 0.0003 kW |
| Nominal heat output | 2.000 kW |
CLICK HERE TO DOWNLOAD ADLER AD 7752 (01) PDF DOCUMENT