3M VFLEX (01) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD 3M VFLEX (01) PDF MANUAL


PDF Content Summary: 3M™ VFlex™ Series Respirators Helping You Wear It Right� These fitting instructions must be followed each time a VFlex™ respirator is worn. 1 Prepare to use respirator Place fingers from both hands on top a b of the nosepiece and both thumbs underneath. Bend slightly at center of nosepiece (1a). Unfold the respirator by pulling top part (with nosepiece) up and bottom part down so the respirator is open all the way (1b). Straps should be held on the top panel. 2 Place respirator on face a b c d e Pull second strap over your head Pull one strap over your head and Place respirator against your face red, tabs on side of respirator can j e fit by pull ng If desi Ad ust for a comfortabl i

position it around your neck and and position it high on the back of

with the bottom under your chin, bottom edge under chin while holding be used to adjust for a comfortable fit (2d).

below your ears (2b). your head (2c).

and the nosepiece across the bridge top edge on nose (2e).

of your nose. Hold respirator on your face with one hand. With your other hand pull the bottom securely under your chin (2a).� 3 Adjust the nosepiece Place your fingertips from both hands at the top of the nosepiece. Use both hands to bend the nosepiece to fit snugly against your nose and face (3). Make certain facial hair, hair, jewelry and clothing are not between your face and the respirator as they will interfere with fit. Make certain respirator is completely opened and edges lay flat against the face. 4 Check the respirator to face seal Perform a User Seal Check. To check the respirator-to-face seal, place both hands completely over the respirator and exhale (4). Be careful not to disturb the position of the respirator. Removal instructions See step 2b and place hand over respirator to maintain

The respirator may not fit as well position on face.

WARNING if you pinch the nosepiece using one hand. Use two hands. Slide fingers down both sides of the nosepiece to seal it against your nose and face. If air leaks around the nose, readjust the nosepiece as described in step 3. If air leaks around respirator edges, adjust position of straps and make certain respirator edges fit snugly against the face. If you CANNOT achieve proper seal DO NOT enter the contaminated area. Remove strap resting high on the back of your head. Still holding respirator in position, pull strap resting on your neck over your head and remove respirator.

These respirators help reduce exposures to certain airborne particulates. Before use, the wearer must read and understand the User Instructions provided as a part of the product packaging. A written respiratory protection program must be implemented meeting all the requirements of OSHA 1910.134 including training, fit testing and medical evaluation. In Canada, CSA standards Z94.4 requirements must be met and/or requirements of the applicable jurisdiction, as appropriate. Misuse may result in sickness or death. For proper use, see package instructions, supervisor, or call 3M OH&ESD Technical Service in USA at 1-800-243-4630 and in Canada at 1-800-267-4414. Please recycle. Printed in USA.

Occupational Health and 3M Canada Company OH&ESD Environmental Safety DivIsion P.O. Box 5757 3M Center London, Ontario N6A 4T1 Building 235-2NW-70 Canada St. Paul, MN 55144-1000 3M, VFlex and the color yellow for earplugs are trademarks of 3M Company, used under license in Canada. © 2010 3M Company. All rights reserved. 70-0715-7410-0


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply