Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** 3MTM 8835 Dust/Mist/Meta1 Thread top elastic strap through top buckles. Repeat for bottom strap and buckles. Place the bottom elastic strap around the head just below the ears. Untwist the strap. Adjust tension by pulling tabs of each strap, as shown. Strap tension may be decreased without removing respirator from the head by pushing out on the back of the buckles. Fume Respirator Place the top elastic strap around the head, above the ears. Untwist the strap. Using both hands, mould metal nosepiece comfortably to shape of nose. Pinching the nosepiece using one hand may result in less effective respirator performance. The seal of respirator on the face should be fit-checked prior to wearing in the work area. (a) Cover the front of the respirator with both hands, being careful not to disturb the position of respirator. (b) Inhale sharply. A negative pressure should be felt inside respirator. If any leakage is detected, adjust position of respirator and/or tension of strap. Retest the seal. Repeat the procedure until the respirator is sealed properly. If you cannot achieve a proper fit do not enter contaminated area. See your supervisor. 3MTM 8835 Dust/Mist/Metal Fume Respirator 3M 8835 Dust/ Mist/Metal Fume Respirator Standard: ENI 49:2001 Type: FFP3D Maximum Use Concentrations: 20 x WEL* for Particulates 20 x WEL* for Metal Fume Approval: CE marked *Workplace Exposure Limit This respirator should not be used in oxygen deficient environments, for escape purposes or by people with beards/ facial hair or in atmospheres where concentrations of contaminant may exceed that deemed Immediately Dangerous to Life and Health (IDLH) 3M Health & Safety Helpline Telephone: 0870 60 800 60 3M.com/uk/ohes For callers within the Republic of Ireland: 1 800 320 500
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL