Free English VALCOM V-9912P-12 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD VALCOM V-9912P-12 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the installation instructions for the VALCOM V-9912P-12?
The VALCOM V-9912P-12 may be conveniently installed from ground level by following these steps:
1. Cut a 12 inch (305mm) diameter hole in the ceiling.
2. Attach four J-nuts to the inside diameter of the ring and line them up with the holes.
3. Snap the ring at the break-slot and maneuver it up through the hole to rest above the ceiling.
4. Attach the speaker grille to the J-nuts of the ring with screws.
What type of ceiling applications is the VALCOM V-9912P-12 designed for?
The VALCOM V-9912P-12 plastic ring is designed for use in retrofit gypsum (sheetrock) ceilings. It is specifically intended for round 8-inch speaker assemblies in retrofit applications.
Are there specific ordering requirements for the VALCOM V-9912P-12?
Yes, the VALCOM V-9912P-12 must be ordered in multiples of 12.
CLICK HERE TO DOWNLOAD VALCOM V-9912P-12 (01) PDF DOCUMENT