TRUVISION TVB-PM (01) PDF Document

The specifications for the TRUVISION TVB-PM are as follows:

Dimensions: 250 x 127 x 140 mm (9.84 x 5.0 x 5.5 in.)

Weight: 1.386 kg (3.056 lb.)

The TRUVISION TVB-PM pole mount adapter can be used with the following bullet cameras:

TVB-5604, TVB-5605, TVB-5606

The following accessories are included with the TRUVISION TVB-PM:

Hose clamps: 3 pieces (Used to install the TVB-PM pole mount adapter to a pole)

Screw A: SC-HSFM8×25-SUS, four pieces with flat washer. (Used to install an S6 Bullet VF Lens Camera (w/o cable harness) to the pole mount adapter.)

Screw B: Four pieces (Used to install the bullet camera adapter plate to the pole mount adapter.)

Screw A:

Length: 25 mm (0.98 in.)

Head Diameter: 13 mm (0.51 mm)

Head Height: 5.3 mm (0.21 in.)

Washer Thickness: 1 mm (0.04 in.)

Screw B:

Total Length: 18 mm (0.71 in.)

Threaded Length: 16 mm (0.63 in.)

Type: M4 (0.16 in.)

Before installing the TRUVISION TVB-PM, you must ensure that the pole is strong enough to withstand more than eight times the weight of the camera and pole mount adapter.

To attach a bullet camera to the TRUVISION TVB-PM pole mount adapter:

1. Install the pole mount mounting plate to the pole using the three hose clamps. Route the cables through the mount.

2. Install the bullet camera adapter plate to the pole mount with screw B.

3. Install the bullet camera back box to the adapter plate.

4. To complete the installation, refer to the installation instructions for the specific bullet camera.