SOUNDTUBE RS1201I SUB (01) PDF MANUAL


Post questions, comments, reviews or errors in the comment box below.

Your File is Ready … Download PDF

CLICK HERE TO DOWNLOAD SOUNDTUBE RS1201I SUB (01) PDF MANUAL


PDF Content Summary: RS1201i Sub RS1201i Sub Box contents 1 Speaker 2 SpeedClampsTM 1 Release key (small hex wrench) Secure anchor point 1 Hanging cable 1 Safety cable Hanging or safety cable 1 Terminal weather boot 1 Euroblock connector SpeedClampTM 1 Grille-mounted tap switch cover 4 Zip ties Safety cable with clip Hanging cable with clip Signal wire Terminal weather boot Euroblock connector Euroblock jack Surface-mount bracket insert Grille-mounted tap switch cover (except RS4-EZ) 913.663.5600 | 800.647.TUBE | http://www.soundtube.com RS1201i Sub © 2008 SoundTube Entertainment, Inc. All rights reserved. PN INS-RS1201i Rev 8.26.19 Warning Warning SoundTube speakers must be installed by a professional audio installer/contractor. For safety and for Do not spec or install speaker near support beam, ventilation duct or optimum audio performance, installer must follow all directions issued by SoundTube Entertainment. other structure that may interfere with speaker function or dispersion. RS1201i Sub RS1201i Sub Speaker 1 Speaker 2 Source 1. Select the tap position by removing the rubber plug on grille to access rotary switch. The tap switch has 2 settings: 4 ohm and 36 ohm (for 70.7V 138W/100V 276W). Select the desired setting and reinsert rubber plug. Note: The grille-mounted tap switch cover is keyed; be sure flat edge of plug lines up with flat edge of hole in grille. 2. Slip terminal weather boot over signal wire. For environmental applications, put RTV silicone around nipple and base when installation is complete. 3. Connect signal wire to 4-pin Euroblock plug. Tighten unused terminal screws. Use inside positive and negative inputs for either voice coil or distributed systems. For daisy chaining, use outside positive and negative terminals. 9. Attach hanging cable to the center hole in the speaker hanging bracket. 4. When daisy chaining, wire the outside terminals to the inside terminals of the next speaker. This step only applies to tap settings using the transformer and not when the speaker is used on bypass. 5. Thread hanging or safety cable through SpeedClampTM mechanisms as shown. 6. Attach the hanging cable 7. Thread cable end(s) by securing it and safety through SpeedClampTM cable to structure as shown. mechanisms as shown. 10. Attach the safety cable to one of the secondary holes in the hanging bracket. 8. Adjust speaker hanging height with SpeedClampTM mechanism. Pull to tighten & insert release key (small hex wrench) into SpeedClamp TM as shown to loosen or adjust. 11. Insert 4-pin Euroblock 12. Use zip or twist-lock ties plug into Euroblock jack on to secure safety cable & signal rear of speaker. Connectors wire to main hanging cables. are keyed for polarity. Cable cover available for asthetic applications (SLT-10). SoundTube also provides optional surface mount brackets for both the RS and HP lines of products. Installation instructions for these accessories are included with specific accessory packaging.


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL

Leave a Reply