LORD G2 2.GN (01) PDF MANUAL

Step 1

Take out 4 screws (1) and handle base (2) from accessory bag.

Then fix the handle base (2) with door by 4 screws (1).

Step 2

Insert handle cover (3) in the handle base (2) until a click.

Step 3

Screw lock catch (4) on the freezer cabinet by another 2 screws (1).

Table: Space Required In Use

Model	W1/mm (Product Width)	D1/mm (Product Depth)	H1/mm (Minimum Heigth)	C1/mm (Minimum Clearance)
G1	705	545	1450	100
G2	905	545	1450	100
G3	954	616	1500	100
G4	1120	700	1600	100
G5	1300	700	1600	100
Remark: D1 doesn’t contain the external handle size.

The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the cabinet.

Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician.

Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand new product, then dry thoroughly.

Important! Do not use detergents or abrasive powders, as these will damage the finish.

Key Operation

A. Fridge/Freezer Temperature Adjustment

Press “Fridge” key to adjust the temperature of Fridge Mode. Fridge range: 2~6°C

Press “Freezer” key to adjust the temperature of Freezer Mode. Freezer range: -14~-25°C

B. Locking / Unlocking:

The system will be automatically locked 30 seconds after the last key operation.

After locking, pressing any key, the panel will flash twice with two beeps. The operation is invalid.

The system will be unlocked after pressing “Fridge” key and “Freezer” key for 3 seconds at the same time.

Super Freezing Mode

Press “Super” key to enter Super Freezing mode. The panel display “SF”. When the Super Freezing mode lasts for more than 52 hours, it will automatically exit this mode and back to the former temperature setting before getting into this mode.

Other Instruction

A. Super Freezing Mode Restriction

While setting the temperature of Fridge Mode, the system can not enter Super Freezing Mode.

Under Super Freezing Mode, press “Fridge” key can not adjust the temperature.

B. Temperature Change Speed

Holding the “Fridge” key or “Freezer” key, the temperature would change consecutively.

Place the fresh food to be frozen in the bottom compartment.

The maximum amount of food that can be frozen in 12 hours is specified on the rating plate.

The freezing process lasts 12 hours: during this period do not add other food to be frozen.

When first starting-up or after a period out of use. Before putting the product in the compartment let the appliance run at least 2 hours on the higher settings.

Important! In the event of accidental defrosting, for example the power has been off for longer than the value shown in the technical characteristics chart under “rising time”, the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooked).

Deep-frozen or frozen food, prior to be used, can be thawed in a fridge compartment or at room temperature, depending on the time available for this operation.

Small pieces may even be cooked still frozen, directly from the freezer. In this case, cooking will take longer.

• the maximum quantity of food which can be frozen in 12 hrs. is shown on the rating plate;

• the freezing process takes 12 hours. No further food to be frozen should be added during this period;

• to start the SUPER function 24 hours before placing food in appliance can help the best freezing capacity;

• make sure that the commercially frozen foodstuffs were adequately stored by the retailer;

• be sure that frozen foodstuffs are transferred from the food store to the freezer in the shortest possible time;

• not open the door frequently or leave it open longer than absolutely necessary.

• Once defrosted, food deteriorates rapidly and cannot be refrozen.

• Do not exceed the storage period indicated by the food manufacture.

For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly.

Caution! The appliance may not be connected to the mains during cleaning. Danger of’ electrical shock! Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, danger of electrical shock! Hot vapors can lead to the damage of plastic parts. The appliance must be dry before it is placed back into service.

Important! Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice or the juice form orange peel, butyric acid, cleanser that contain acetic acid.

• Do not allow such substances to come into contact the appliance parts.

• Do not use any abrasive cleaners

• Remove the food from the freezer. Store them in a cool place, well covered.

• Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker of fuse.

• Clean the appliance and the interior accessories with a cloth and lukewarm water.

• After cleaning wipe with fresh water and rub dry.

The freezer, however, will become progressively covered with frost. This should be removed.

Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.

However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows:

• Unplug the unit. Remove the drain plug from the inside of the freezer. Defrosting usually takes a few hours. To defrost faster keep the freezer door open.

• For draining, place a tray beneath the outer drain plug. Pull out the drain dial.

• Rotate the drain dial 180 degree. This will let the water flow out in the tray. When done, push the drain dial in. Replug the drain plug inside the freezer compartment. Note: monitor the container under the drain to avoid overflow.

• Wipe the interior of the freezer and replace the electrical plug in the electrical outlet.

• Reset the temperature control to the desired setting.

Problem	Possible cause	Solution
Appliance does not work	Mains plug is not plugged in or is loose	Insert mains plug.
Appliance does not work	Fuse has blown or is defective	Check fuse, replace if necessary.
Appliance does not work	Socket is defective	Mains malfunctions are to be corrected by an electrician.

Problem	Possible cause	Solution
Appliance freezes too much	Temperature is set too cold or the appliance runs at “7” setting.	Turn the temperature regulator to a warmer setting temporarily.

Problem	Possible cause	Solution
The food is not frozen enough	Temperature is not properly adjusted.	Please look in the initial Temperature Setting section.
The food is not frozen enough	Door was open for an extended period.	Open the door only as long as necessary.
The food is not frozen enough	A large quantity of warm food was placed in the appliance within the last 24 hours.	Turn the temperature regulation to a colder setting temporarily.
The food is not frozen enough	The appliance is near a heat source.	Please look in the installation location section.

Problem	Possible cause	Solution
Heavy build-up of frost on the door seal.	Door seal is not air-tight.	Carefully warm the leaking sections of the door seal with a hair dryer (on a cool setting). At the same time shape the warmed door seal by hand such that it sits correctly.

Problem	Possible cause	Solution
Unusual noises	Appliance is not level.	Check the appliance and level it by some articles.
Unusual noises	The appliance is touching the wall or other objects.	Move the appliance slightly.
Unusual noises	A component, e.g. a pipe, in the side of the appliance is touching another part of the appliance or the wall.	If necessary, carefully bend the component out of the way.

When LED lamp does not work when door is open, please contact an authorized service.