Post questions, comments, reviews or page errors in the comment box below.
PDF Content Summary:
****** Page 1 ****** INSTALLATION INSTRUCTIONS Model IN-3-XX Indicator Panel The Model IN-3-XX Indicator Panel contains an ammeter to indicate battery charger output current and a neon indicator to indicate power input to the vehicle. The panel is designed to cover a 2 1/2″ hole in the vehicle. To Mount the IN-3-XX• 1 Locate a suitable spot on the vehicle and mark the center of the desired location. 2. Place the panel over the “center mark” so that the opening is precisely in the middle of the rectangular opening. 3. Mark the location of the four corner holes. 4. Center-Punch the “center mark” and the four corner holes. 5. Drill out the center hole with a 2 1/2″ hole saw and the four corner holes with a 5/32″ diameter drill. 6. Remove the protective laminate from the front of the panel and assemble the meter and neon indicator to the panel. 7. Connect the neon indicator so that it is energized when power is applied to the vehicle (see schematic). 8. Mount panel to the vehicle with the four # 6-32 screws provided. 9. Connect the ammeter in series with the common output of the charger (see schematic). # 6-32 Screw Neon Indicator Meter Lock Bezel Assembly Hex Nut (x4) o o Ground or Battery (-) LINE COM o o Rear View of Indicator 120 V.A.C. Power Input from the Battery Charger Common or (-) From the Output of the Battery Charger Schematic SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS KUSSMAUL ELECTRONICS COMPANY, 170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA INC. TEL. In NY: 631 567-0314 TOLL FREE: 800 346-0857 FAX: 631 567-5826 November 18, 2004
FREE ENGLISH PDF
USER GUIDE – USER MANUAL
OWNER GUIDE – OWNER MANUAL
REFERENCE GUIDE – REFERENCE MANUAL
INSTRUCTION GUIDE – INSTRUCTION MANUAL