ILUV TB100S (01) PDF Document

When using the ILUV TB100S for the first time, please follow these steps:

1. Leave the earbuds in the charging case for 30 minutes to charge both the earbuds and the case.

2. After they are fully charged, take the earbuds out of the charging case.

3. Play test audio at 50% volume for a minimum of 15 minutes to eliminate any inconsistent sound from the earbuds.

If the ILUV TB100S earbuds are desynced from one another, you can reset the connection with these steps:

1. Place both earbuds into your ear.

2. Tap the center of both earbuds twice. If you hear a beep sound from both earbuds simultaneously, then your earbuds are paired and you are good to go.

The ILUV TB100S earbuds are designed to automatically restore connection with the last paired device when powered on. If you are having issues, try the following:

1. The simplest way to restore connection is to place the earbuds in the charging case.

2. Close the lid and take them out after 5 seconds.

If this doesn’t resolve the problem, reset your Bluetooth on your device while the earbuds are in pairing mode. If this doesn’t work, you may need to restart your mobile device.

1. Place both earbuds in the charging case for 15 minutes then remove them; both earbuds will automatically power on for use.

2. To confirm the case’s battery strength, plug in your USB charger. Four LED’s will indicate the charging case is fully charged.

3. Please also make sure to check if the USB adapter or the wall outlet is working.

The ILUV TB100S sound quality may decrease whenever dust or wax impacts the speaker mesh of the earbuds. Please make sure to check for impacted areas and clean the speaker mesh often to ensure good sound quality.

1. Clean the charging pins on the earbuds.

2. Clean the earbud mesh.

3. Clean the case charging pins.