FELLOWES 8018001 (01) PDF Document

The FELLOWES 8018001 keyboard tray includes the following components:

A – Glide Track

B – Arm

C – Cover

D – Keyboard Platform

E – Mouse Pad

F – Wrist Rest

G – Wood Screws (x8)

H – Machine Screws (x4)

I – Short Screws (x2)

J – Long Screws (x2)

K – Washers (x4)

L – Adhesive Strips

M – Cable Clip

N – Cable Clip

Step 1. Position the glide track (A) on the underside of your desk. For proper placement, the front of the track should be 7/8 inch (22.25mm) from the front edge of the desk.

Step 2. Secure the glide track to the desk using four wood screws (G) and four washers (K).

Step 1. Once the glide track is installed, slide the arm (B) fully into the glide track (A).

Step 2. Place the cover (C) onto the back of the arm mechanism.

Step 3. Align the keyboard platform (D) with the arm (B) and secure it from underneath using the four machine screws (H).

Step 1. The mouse pad (E) can be installed on either the right or left side of the keyboard platform (D) to accommodate right-handed or left-handed users.

Step 2. Align the mouse pad with the pre-drilled holes on your chosen side of the keyboard platform.

Step 3. Fasten the mouse pad from underneath using the two long screws (J) and two short screws (I).

Step 1. Take the adhesive strips (L) and apply them to the back of the wrist rest (F).

Step 2. Remove the protective backing from the adhesive strips.

Step 3. Align the wrist rest (F) with the front edge of the keyboard platform (D) and press down firmly to secure it in place.

To adjust the height: Lift the front of the keyboard platform to the desired height. Lower it slightly to lock it into position.

To adjust the tilt: Loosen the adjustment knob on the side of the arm. Position the keyboard platform at your preferred angle, then tighten the knob to secure it.

Yes, the keyboard platform can be swiveled to the left or right. Simply hold the platform and rotate it to your desired position.

The FELLOWES 8018001 comes with two cable clips (M and N) for cable management. Attach clip M to the arm of the keyboard tray and clip N to the underside of your desk to guide the keyboard and mouse cables and keep them organized.