EVOLVEO G 650 (01) PDF DOCUMENT

EVOLVEO G gaming power supplies are equipped with several protections to ensure safe operation, including the following:

(OVP) Over Voltage Protection

(UVP) Under Voltage Protection

(OPP) Overload protection

(SCP) Short circuit protection

(OCP) Overcurrent protection

(OTP) Overtemperature protection

1. Remove the power supply from its packaging.

2. Use the included screws to install the power supply into your computer case. We recommend installing the power supply with the fan pointing downwards. However, if the power supply will be placed on the bottom of your computer case and there are no ventilation holes, it may be best to install the power supply with the fan facing upwards to ensure greater efficiency and reliability.

3. Connect the 24-pin ATX cable to the motherboard. This power supply allows you to disconnect the four pins on the far right to make this connector a 20-pin connector. Under no circumstances should you plug another 4-pin connector into the 4-pin ATX12V or “P4” connector on the motherboard. Serious damage can occur.

4. Connect the 8pin EPS12V cables to the motherboard. One of the EPS12V connectors can be split to create a 4pin ATX12V connector if your board does not have an EPS12V connector.

5. Connect the 12+4pin PCIe 5.0 cables to your graphics card(s). COMMENT: If the PCIe 5.0 connector is not sufficiently connected, it may heat up and then burst into flames!

6. Connect the SATA cables to the drives of your system (Hard drives, SSDs and optical drives). If your board supports additional PCIe power via the SATA connector, connect a SATA cable to the motherboard as well.

7. Connect “molex” peripheral connectors to the power supply and to fans, hard drives and other devices.

8. Connect the AC power cord to the power supply and to a wall outlet and turn the power switch to the ON position.

INPUT PARAMETERS OF THE SOURCE, OUTPUT VOLTAGE, CURRENT, AND POWER OF THE SOURCE
Input	100-240VAC 10A 50/60Hz
DC Output	+3.3V	+5V	+12V	-12V	+5VSB
Max. Current	20A	20A	54.2A	0.3A	3A
Max. Power	103W		650W	3.6W	15W
Total Power	650W

Do not pull the power cord out of the socket by the cable.

Do not connect or pull the power cord into the socket with wet hands.

Do not connect the adapter to the mains if you find that the adapter is damaged (e.g. short circuit, burnt PVC cover).

Immediately unplug from the mains if you smell a burn.

Do not disassemble this equipment, do not attempt to modify it in any way there is a risk of fire, injury or damage to personal property. Entrust all repairs to an authorized service.

Do not expose it to direct sunlight or place it on a heater or other heat source. Do not cover it with paper or other material to allow air to circulate.

Do not use in environments where the temperature is below 0°C and above 40°C. Use in ventilated areas.

Do not place the adapter in areas that are sensitive to heat.

Make sure that your power source supplies the correct voltage (V) and frequency (HZ).

Do not use the adapter with damaged leads, output cables or fuses.

Keep out of reach of children.

Make sure that the output voltage of this power adapter is appropriate for your device.

Disconnect the device from the mains if you will not be using it for an extended period of time.

Connect the connectors according to the instructions and guidelines of the peripheral manufacturer (HDD, MB, CPU/GPU, …)

Check the power rating of the peripherals and make sure it matches the output of the power supply.

Higher-end power supplies may have a passive cooling feature, the fan will only turn on when the power supply is hot or loaded.