Click here to download ELINCHROM RANGER RX SPEED (01) PDF MANUAL

PDF Content Summary:

****** Page 1 ****** elinchrom Operating Manual angerRX Speed / Speed AS Battery Power Pack (Asymmetric version) Ranger RX Sp•eod Ranger RX Speed AS Elinca S.A Ranger RX speed AS 01.08.2007 ENG (73305) Printed in Switzerland English

****** Page 2 ****** Table of contents Introduction Declaration of conformity, disposal and recycling, CE marking Safety notice and precaution Before you start Control Panel Functions Synchronisation, EL Wireless system Change the battery Battery charging, battery fuses Flashhead connections Ranger Flashheads Technical Data Elinchrom Accessories Guarantee PS: Tecllnical data subject to change. 2 3 4 5 6 7-8 9 9 10 10 11 12 13 14 The listed values are guide values which may vary due to tolerances in components used. 1

****** Page 3 ****** Introduction The Elinchrom Ranger RX Speed S/AS is manufactured by Elinca S.A. CH -1020 Renens/Switzerland Dear Photographer, Thank you for buying your Ranger RX Speed S/AS autonomous flash unit. All Elinchrom products are manufactured using the most advanced technology. Carefully selected component are used to ensure the highest quality and the equipment is submitted to many controls both during and after manufacture. We trust that it will give you many years of reliable service. All flash units are manufactured for the studio and location use of professional photographers. Only by observance of the information given, can you secure your warranty, prevent possible damage and increase the life of this equipment. Ranger RX Speed / AS The quality of light and exceptional performance is the result of long research, application of demanding principles, the long experience of ELINCHROM in lighting products for the studio and the utilization of the latest technology in this area. Totally integrated to the range of the ELINCHROM flashes, the Ranger RX Speed S/AS units maintain the traditional look and function that is ELINCHROM. FCC Class B Compliance Statement Note: This equipement has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 ofthe FCC Rules and meets all requirements ofthe Canadicm Interference-Causing Equzpement Regulations. These limits are designed to provide reasonable protection against Imrmful interference in a residential installation. This equtpement generates, uses, and can radiate radiofrequency energy and, ifnot installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipement does not cause harmful interferences to radio or television reception, which can be determined by turning the equipement offand on, the user is encouraged to correct the interferences by one or more ofthefollowing measures: Reorient or relocate the receiving antenna. – Increase the separation between the equwement and receiver. Connect the equipement into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/7V technician for help. ELINCA SA is not responsible for any radio or television interference caused by unauthorised modifications of this equipement or the substitution or attachment ofconnecting cables and equipement other than those specified by ELINCA SA The correction of interference caused by such unauthorised modification, substitution or attachment will be the responsibility ofthe user. 2

****** Page 4 ****** Declaration of conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Product name: Trade name: Model number(s): Name of responsible party: Phone Fax: Professional Studio Flash unit ELINCHROM Ranger RX Speed S/AS Elinca S.A Av. De Longemalle 11 1020 Renens / Switzerland +41 21 637 26 77 +41 21 637 26 81 We, ELINCA S.A., hereby declare that the equipement bearing the trade name and model number specified above was tested conforming to the applicable FCC rules, and that all the necessary steps have been taken and are in force to assure that the production units of the same equipement will continue to comply with the Comissions requirements. Disposal and recycling This device has been manufactured to the highest possible degree from materials which can be recycled or disposed of in a manner that is not enviromentally damaging. The device may be taken back after use to be recycled, provided that is turnedinaconditionthatistheresultofnormaluse.Anycomponentsnotreclaimed will be disposed of in a environmentally acceptable manner. If you have any question on disposal, please contact your local office or your local ELINCHROM agent (check our website for a list of all ELINCHROM agents world wide). CE marking The shipped version of this device complies with the requirements of ECC directives 89/336/ECC <<Electromagnetic compatibility» and 73/23/ECC <<Low voltage directive». Notational Conventions The meaning of the symbols and fonts used in this manual are as follows: i Pay particular attention to text marked with this symbol. Failure to observe this warning endangers your life, destroys the device, or may damage other equipement Supplementary information, remarks, and tips follow this symbol. Text which follows this symbol describes activities that must be performed in the order shown. <<Quotation marks» indicate names of chapters or terms 3 ****** Page 5 ****** User Safety Information • Do not use in restricted area (like hospitals) • Do not use in explosive envirronements Travelling by Air (as well as any other transport option) Due to strict security regulations, please note : • Remove the 40 A fuse from the top side of the Battery Box, this desactivates the internal < overheating => Battery related problems => Internal defect • Switch off the unit and let it cool down for at least 10mn • Needs recharging • Battery charging fuse is brocken, replace fuses (page 10) • Charger is brocken • Battery is out of lifetime • Do NOT open the unit yourself! • Bring your Ranger RX (with charger, heads, battery & cables) to an Elinchrom service. 12

****** Page 14 ****** Elinchrom Accessories Reflectors Grids Filters Lightbanks ROTALUX Umbrellas Spots Stands Trigger accessories Wide angle ø 16 cm /900 Compact ø 18 cm /600 Standard ø 21 cm 1500 Mini soft ø 44 cm silver Mini soft ø 44 cm white Snoot & Grid Grid for snoot Grid set for reflector 18 cm Grid set for 21 cm Set of 10 color/mixed filters for 21 cm x 21 cm Polarizing filter 21 cm Square 70 x70 cm Square 100 x100 cm strip 95 x 35 cm Rectangular 130 x 50 cm Octagonal 100 cm Octagonal 135 cm White diam. 85 cm Silver diam. 83 cm Translucent diam. 85 cm Zoom spot 180 – 360 Mini spot Stand 85-235cm Stand Master 109-385 cm Universal Set (lx Transmitter, lx Universal Receiver and cables) EL-Skyport Computer remote set EL-Skyport RX Set (need adaptator) EL-Skyport RX Adaptator for Ranger RX Accessories for Ranger RX S/AS (only) Ranger RX Heads Modelling lamps (12V) Battery Box, including battery Adapter cable Ranger RX pack to EL standard flashheads Shoulder strap for Ranger RX Ranger S Standard Flashhead Ranger A Action Flashhead Ringflash 1500 Ranger/Free Lite extension cable 4m Quartz Halogen, GX 6,35 – 12V / 50 W Quartz Halogen, GX 6.35 – 12V / loow code 26143 26144 26141 26166 26168 26061 26427 26135 26051 26243 26244 26178 26179 26180 26181 26183 26184 26372 26350 26371 26481 26420 30101 30149B 19360 19361 19362 19374 19280 11095 19289 20100 20101 20493 11096 23044 23046 oo oo 13

****** Page 15 ****** GUARANTEE This ELINCHROM product will be repaired free of charge by the vending agent if during a period of 24 months from date of purchase its working order is impaired through a manufacturing or material defect. The faulty product should be immediately sent to the authorized dealer or ELINCA agent. This guarantee is not valid for equipment which has been misused, dismantled, modified or repaired by persons not belonging to the ELINCA distribution network. It does not cover flash tubes, lamps and the normal ageing of capacitors. No responsibilities can be accepted for damage resulting from unsatisfact01Y operation of the equipment, such as wasted film or other expenses. i Please „register” your Elinchrom product online, under > Downloads > Product Registration In case you cannot register your Elinchrom unit via internet, please fill in the Guarantee card and post it to Elinca. Please return this registratioin card directly to Diese Registrierkarte bitte direkt zurücksenden an Veuillez retourner cette carte d’enregistrement directement å Vi preghiamo di far pervenire questa cartolina di iscrizione direttamente a Por favor envie esta carta de registro directamente Elinchrom model Elinchrom modéle Elinchrom modell Modello di Elinchrom Modelo de Elinchrom elinca sa P.O. Box 458 Avenue de Longemalle 11 CH-1020 Renens Switzerland NO Date of purchase Datum des Kaufs La date d’achat La data di acquisto La fecha de la compra Dealer Händler Négociant II distributore El comerciante Your full name and address Ihr voller Name und redet an Votre nom complet et adresse II suo nome pieno ed indirizza Su nombre y apellidos y dirige 14

****** Page 16 ******








Leave a comment, question, review or page error below. Account not required.

This site uses Akismet to reduce spam. Learn how your comment data is processed.