DIAMOND AUDIO DMD35 (01) PDF MANUAL

DIAMOND AUDIO DMD35 (01) PDF SUMMARY:

How do I configure my speakers as a coaxial system?

You have the option of configuring your speakers as a coaxial system (tweeter attached) or a component system (tweeter separate). If your choice is to use as a coax then you will need to attach the tweeter to the midrange. Locate the supplied tweeter post support and attach the tweeter as shown. Remove the rubber boot from the midrange; guide the tweeter wires down through the middle of the midrange. Guide the tweeter wires so that they lay in the groove of the inside of the rubber boot as it replaced. Attach wires to the proper terminals.

How do I flush mount tweeters?

When flush mounting tweeters, make sure the desired location can accommodate the hole size and depth required. Mount the cup using provided hardware. Mount surface cup at desired angle with provided screws in tweeter mounting kit. Route speaker wires through tweeter cup, connect tweeter to wires, and snap tweeter into cup by aligning the notches. Mounting Hole size: 1.36” (34.5mm) Dia.

What should I do before mounting mid-bass speakers in the door?

Determine a location in the door that will accept the size of your new speaker. Remove the door panel from the door and check for clearance in the intended speaker location while operating the window all the way up and down. Avoid cutting any structural metal to mount the speakers or to accommodate additional depth. If depth or a flat surface mount are an issue, please seek the skills of a professional installation technician.

What should I consider when mounting speakers in the rear of the vehicle?

When mounting the speakers in the rear of the vehicle, there are often two options for achieving a good mount. Some speakers mount from the top side (from the interior) while other applications have the speakers mounted from the bottom side (from the trunk). In either case, a flat mounting surface and a good seal are still extremely important.

What is covered under the product warranty?

Diamond Audio Technologies warrants this product to be free from defects in material and workmanship for a period of one (1) year from the original date of purchase provided it was purchased from an authorized DAT retailer within the United States. Product warranty period starts at date of purchase or one year past manufacture date whichever is first. However, upon purchase, completion of the online registration and installation by an authorized DAT dealer your warranty period will be extended to two (2) years. This warranty extension offer will only be recognized upon completion of the online registration of your product within 30 days of the date of purchase. Should a manufacturing defect occur during above said warranty period, DAT will replace or repair the defective product with a product of the same or equivalent value and performance.

What is not covered under the warranty policy?

Damage or failure caused by any of the following is not covered under this warranty policy: negligence, improper use, abuse, product modification, unauthorized repair attempts, accident, acts of God, misrepresentations by DAT retailers, and improper/inadequate packaging during return shipping. Warranty is void if serial numbers have been removed, altered or defaced.

How do I obtain warranty service?

In the event a DAT product should require service, you should visit the authorized DAT retailer you purchased the product from and they can expedite your claim. All claims must fall into the guidelines listed above and be accompanied by a copy of the original sales and installation receipt from that authorized DAT retailer. Product returned for warranty service must be freight-prepaid, properly packaged and clearly marked with the Return Authorization (RA) number issued by DAT. Any product returned to DAT that is improperly packaged, does not have a RA number clearly marked on the package, or never received a RA number may be refused upon delivery. DAT does not assume responsibility for lost or misdirected product.