AXIS M4227-LVE (01) PDF DOCUMENT

There are several risks when disassembling or assembling your AXIS M4227-LVE. Some of the risks include:

ESD Damage – Always handle the product in an ESD safe environment. Even if precautions are taken, there is always a risk of ESD damage. The damage can remain undetected and cause problems during the lifetime of the equipment.

Dust contamination – Opening the AXIS M4227-LVE may expose the lens and sensor to dust or paint. Dust will affect the optical performance. Lenses need to be disassembled in a dust-free environment, preferably a cleanroom.

Paint overspray – Masking the different components of the equipment is critical. Failure to mask sensitive areas can cause problems with assembling the equipment. Any areas that are not painted at the factory or have a different surface treatment than the rest of the parts (threads, ground and electrical contact surfaces) must also be masked to ensure function.

Preparations

Before painting your AXIS M4227-LVE, follow these preparation steps:

• If applicable, disassemble the device according to the instructions in this document.

• Clean all parts that will be repainted thoroughly to remove grease, dust, or oil.

• To ensure reassembly and functionality of the product, mask any openings (for example for screws, LED indicators, or microphones) before you paint.

• To avoid unwanted reflections, mask the inside of the weathershield before you paint.

Pretreatment of parts

Before you apply a new coating, we recommend the following pretreatment:

• Apply a primer layer suitable for the specific material, to increase adhesion to the parts.

The material used in the product is PC Makrolon 6487RE 700190.

To disassemble the AXIS M4227-LVE, follow these steps:

1. Turn the cover top counterclockwise and remove it.

2. Use a flat screwdriver to release the clamp brackets from the camera and the dome.

3. Remove the camera unit with the dome attached.

4. Remove the dome from the camera unit.

Note: Be careful with the dome gasket, it’s important that this is intact, clean, and in place when you assemble the camera unit and dome.

5. Disconnect the POE cable from the camera.

6. Remove the ring dome from the cover top.

7. To remove the weathershield, remove the screws from the bracket and weathershield.

8. Remove the bracket from the weathershield.

To paint your AXIS M4227-LVE:

1. Make sure you have done all necessary preparations of the weathershield and cover top. It is important to mask the holes for the acoustic sensor.

2. Apply a thin and even layer of spray paint according to the instructions of the paint manufacturer.

Important: Avoid paint build-up in the inner groove of the cover top where it connects with other parts.

3. Let the paint dry.

4. To get better coverage and clearer color, apply a second layer of spray paint.

5. When the paint is dry, remove the masking and reassemble the product.

To reassemble the AXIS M4227-LVE:

1. If you use a weathershield, fasten the bracket to the weathershield and screw back in place.

2. Connect the POE cable to the camera.

3. Attach the dome to the camera unit.

4. Attach the camera unit to the bracket.

Note: The camera must be attached with all 4 clamps. The 2 clamp brackets attach the dome to the camera unit.

5. Put the cover top in place on the camera and push until you hear a click.

Important: Make sure that the holes for the sensor on the cover top go over the acoustic sensor.