Free English ANKO 205324 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD ANKO 205324 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How do I operate the ANKO 205324 LED light?
1. Rotate the bottom cover according to the “open” indication.
2. Unscrew and open the battery cover, insert 3x 1.5V AAA battery.
3. Close the battery cover and screw again.
4. Rotate the bottom cover back.
5. You can turn the light on by press the top button switch.
6. Peel off the tape on the bottom and stick on a smooth, tidy surface.
7. Wipe the dust before stick.
What are the battery requirements for the ANKO 205324 LED light?
Each ANKO 205324 light requires 3×1.5V AAA batteries (not included). Battery installation by an adult is required.
What are the battery warnings for the ANKO 205324 LED light?
Batteries are to be inserted with correct polarity.
Do not mix different types of batteries or new and used batteries.
The supply terminals are not to be short-circuited.
Remove batteries from the product when not in use for extended time or when batteries become exhausted.
Dispose of batteries responsibly.
Do not dispose of in fire.
What are the important safety instructions and warnings for the ANKO 205324?
The following safety precautions should always be followed to reduce the risk of electric shock, personal injury or fire. It is important to read all of these instructions carefully before using the product, and to save them for future reference or new users.
1. Read this user manual thoroughly before first use and pass it on with the product.
2. LED’s are not replaceable. When it reaches its end of life, the whole light shall be replaced.
3. Do not stare into the LED beam.
4. The product is intended to be used in moderate climates only. Do not use in tropical or very humid climates.
5. Do not move the product from cold into warm environments and vice versa.
6. The use of accessories and parts not specifically recommended by the manufacturer may cause injuries or damages.
7. If the product shows damages, do not use it any longer and have it repaired by a qualified technician.
8. Remove the batteries from the product before disposal.
9. Do not attempt to open the LED module to avoid damage.
10. The battery in the product can be replaced but cannot be charged.
11. Children must not use this product without adult supervision.
12. Do not expose the product to fire or high temperatures over 45°C.
WARNING: READ AND FOLLOW ALL ABOVE INSTRUCTIONS CAREFULLY. DO NOT DROP OR APPLY EXCESSIVE FORCE TO THIS PRODUCT. DO NOT EXPOSE TO HIGH TEMPERATURES. IMPROPER USE OR HANDLING OF THIS PRODUCT MAY RESULT IN FIRE OR EXPLOSION CAUSING SERIOUS INJURY OR PROPERTY DAMAGE.
How should I care for, store, and dispose of the ANKO 205324 LED light?
13. Keep away from water, liquids, or wet areas.
14. Use a dry cloth to clean this product. Do not use chemicals on this product.
15. Do not place the product in direct sunlight, heat or the under the windshield.
16. When the unit is not in use, make sure it is correctly turned off and stored in a cool dry place.
17. When disposing of this product, do so responsibly following local government requirements.
What is included in the package for the ANKO 205324?
The package contains 3 lights.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD ANKO 205324 (01) PDF DOCUMENT