ALLEN & HEATH DX012-RK (01) PDF MANUAL

The DX012-RK is an alternative rack ear kit for the DX012 output expander. It positions the unit recessed into a rack, flushed with a companion GX4816 expander or dLive MixRack.

The rack ears can be reversed so the unit is mounted with the XLR connectors facing the rear of the rack, for convenience of patching.

Check that you have received the following:

• 2x rack ears (part number AA12088-L and AA12088-R)

• 6x M3x8mm countersunk screws

• Using a Torx T8 driver, remove the 3x M3x5mm screws holding the standard rack ears in place on each side of the unit.

• Position the AA12088 rack ears in either of the two positions shown (Default position or Rear mounting), and secure them on each side of the unit using the 3x M3x8mm screws provided in the package.

Only use the M3x8mm countersunk screws provided. Do not use the M3x5mm screws from the standard rack ears.

The dimensions are as follows:

Overall Width (including rack ears): 481.60mm / 19″

Chassis Width: 365.00mm / 13.9″

Faceplate Width: 433.00mm / 17″

Height: 44.00mm / 1.7″

Rack Ear Height: 48.20mm / 1.9″

Depth (Default position): 205.00mm / 8.1″ (body), 235.80mm / 9.3″ (overall)

Depth (Rear mounting): 231.00mm / 9.1″ (body), 239.10mm / 9.4″ (overall)