Post questions, comments, reviews or page errors in the comment box below.

Click here to download ABB POWERVALUE 11 LI UP 1000VA (01) PDF MANUAL


PDF Content Summary:

****** Page 1 ****** END OF LIFE TREATMENT PowerValue 11 LI Up 600-2000 VA 220/230/240 v IEC O PREPARED 2019-05-24 APPROVED 2019-08-02 Product Marketing STATUS Approved DOCUMENT KIND End of life treatment DOCUMENT ID. 4NWD005026 SECURITY LEVEL Public OWNING ORGANIZATION ABB, Electrification — Smart Power business Ine @ Copyright 2019 ABB. All rights reserved. REV. LANG. EN PAGE 1/10

****** Page 2 ****** POWERVALUE 11 Contents 1. Important safety instructions 1.1. Symbols and warnings 1.2. Safety rules 2. Introduction 2.1. Related to the document 2.2. Applicability 2.3. Target audience 2.4. Disclaimer 3. Recycling advice 4. Dismantling and recycling instructions STATUS Approved a Copyright 2019 ABB. SECURITY LEVEL Public All rights reserved. DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 2/10

****** Page 3 ****** POWERVALUE 11 Ll UP 1. Important safety instructions THIS CHAPTER CONTAINS IMPORTANT SAFETY INSTRUCTIONS. READ IT CAREFULLY BEFORE STARTING DISASSEMBLING THE UNIT. 1.1. Symbols and warnings The following symbols are used in this manual, the list below explains each symbol. 4 STATUS Approved THIS SYMBOL IN CONJUNCTION WITH THE SIGNAL WORD “DANGER” INDICATES AN IMMINENT ELECTRICAL HAZARD. FAILURE TO OBSERVE THE RELATED SAFETY NOTE MAY CAUSE INJURY, DEATH OR EQUIPMENT DAMAGE. THIS SYMBOL IN CONJUNCTION WITH THE SIGNAL WORD “WARNING” INDICATES A POTENTIALLY DANGEROUS SITUATION. FAILURE TO OBSERVE MAY CAUSE INJURY, DEATH OR EQUIPMENT DAMAGE. DO NOT DISPOSE OF WITH ORDINARY TRASH. SECURITY LEVEL Public DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 3/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 4 ****** POWERVALUE 11 Ll UP 1.2. Safety rules DANGER DANGER STATUS Approved RISK OF ELECTRIC SHOCK: BEFORE DISASSEMBLING THE UNIT, MAKE SURE THE UPS IS COMPLETELY SWITCHED OFF AND INTERNAL CAPACITORS HAVE BEEN DISCHARGED BY WAITING AT LEAST 5 MINUTES AFTER SHUTDOWN THE UNIT. THE UNIT MAY CONTAIN BATTERIES. A BATTERY CAN PRESENT A RISK OF ELECTRICAL SHOCK AND HIGH SHORT CIRCUIT CURRENT. THE FOLLOWING PRECAUTIONS SHOULD BE OBSERVED WHEN DISASSEMBLING A UNIT THAT CONTAINS BATTERIES: A) B) C) D) E) F) REMOVE WATCHES, RINGS OR OTHER METAL OBJECTS. USE TOOLS WITH INSULATED HANDLES. WEAR RUBBER GLOVES AND BOOTS. DO NOT LAY TOOLS OR METAL PARTS ON TOP OF BATTERIES. DISCONNECT THE CHARGING SOURCE PRIOR TO CONNECTING OR DISCONNECTING OF BATTERY TERMINALS. ESTABLISH IF THE BATTERY IS INADVERTENTLY GROUNDED. IF INADVERTENTLY GROUNDED, REMOVE SOURCE FROM GROUND. CONTACT WITH ANY PART OF A GROUNDED BATTERY CAN RESULT IN ELECTRICAL SHOCK. THE LIKELIHOOD OF SUCH SHOCK CAN BE REDUCED IF SUCH GROUNDS ARE REMOVED DURING INSTALLATION AND MAINTENANCE (APPLICABLE TO EQUIPMENT AND REMOTE BATTERY SUPPLIES NOT HAVING GROUNDED SUPPLY CIRCUIT. A BATTERY CAN PRESENT A RISK OF ELECTRICAL SHOCK AND HIGH SHORT CIRCUIT CURRENT. KEEP OUT OF BATTERY POLES WHICH CONTAIN DANGEROUS DC-VOLTAGES CAUSING FATAL ACCIDENTS. INAPPROPRIATE MANIPULATIONS OF THE BATTERIES CAN CAUSE LIGHTNING SPARKS. SECURITY LEVEL Public All rights reserved. DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 4/10 a Copyright 2019 ABB.

****** Page 5 ****** POWERVALUE 11 Ll UP 2. Introduction 2.1. Related to the document The document contains information for end of life recyclers or treatment facilities in accordance with the EU Directive 2012/19/ EU about waste electrical and electronic equipment (WEEE). Necessary dis- mantling information are detailed, together with indication of WEEE materials and components requir- ing selective treatment are located. Substances of very high concern under Regulation (EC) No 1907/2006* are typically used but not re- ported in this document: contact ABB to get the latest declaration available. * Regulation (EC) No 1907/2006 of the European Par/iament and of the Counci/ on the Registration, Eva/uation, Authorisation and Restriction of Chemicals (REACH). 2.2. Applicability This document covers the environmental information of the following products: Product UPS Powervalue IILI Up 600VA UPS Powervalue 11Ll Up BOOVA UPS Powervalue IILI Up IOOOVA UPS Powervalue 11Ll Up 1500VA UPS Powervalue 11Ll Up 2000VA 2.3. Target audience Part number 4NWP100170R0001 4NWP100171R0001 4NWP100172R0001 4NWP100173R0001 4NWP100174R0001 This document is intended for ABB customers and for professional recyclers. “Professional” refers to the expertise in implementing selective treatment according local National laws. That includes also the un- derstanding of immediate or long term safety risks related to exposure to substances. 2.4. Disclaimer The information presented in this publication does not form part of any quotation or contract, is be- lieved to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequences of its use. Publication thereof does not convey nor imply any license un- der patent – or other industrial or intellectual – property rights. STATUS Approved SECURITY LEVEL Public DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 5/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 6 ****** POWERVALUE 11 Ll UP 3. Recycling advice The following table is intended to guide selective treatment and recycling, showing where which sub- stances of concern are used and where they are located [ref. Directive 2012/19/ EU Article 15 and Annex VII]. Substances of very high concern under Regulation (EC) No 1907/20060 are typically used but not re- ported in this document due to changing nature: contact ABB to get the latest declaration available. (1) Regulation (EC) No 1907/2006 of the European parliament and of the Council on the Registration, Eva/uation, Authorisation and Restriction of Chemicals (REACH). Substance(s)/Component(s) Batteries Printed circuit boards (2) Plastic containing brominated flame retardants (BFRS) (2) Liquid crystal displays (> 100 cm2) Spare electrolyte capacitors (height > 25 mm, diam- eter > 25 mm) Polychlorinated biphenyls containing capacitors Mercury containing components Toner cartridges Asbestos components which contain asbestos Cathode ray tubes CFC, HCFC, HFC, HC Gas discharge lamps External electric cables Components containing refractory ceramic fibres Components containing radioactive substances Where used (potential) Used as VRLA block(s). Used. – plastic enclosure, – PVC insulation of internal wiring, – input/output receptacles, – bobbin of 50Hz transformer. Not used. Not used. Not used. Not used. Not used. Not used. Not used. Not used. Not used. Not used. Not used. Not used. (2) due to assembly complexity and where-used indication, the /ocaüon of these substances or materia/ wi// not be indicated a/ong the docu- ment, unless considered necessary STATUS Approved SECURITY LEVEL Public DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 6/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 7 ****** POWERVALUE 11 Ll UP Other materials and components, when not indicated above: High level component Original packaging Fasteners Cables with end terminals Substance(s) – Paper, – Polyethylene foam or film – Steel, zinc plated – Copper, – Brass, – PVC, – Nylon, – PBT The following electrical components require further separation after removal from UPS. They might con- tain materials or components requiring selective disposal. Contact the manufacturer to get proper in- structions: 50Hz Transformer; fan. STATUS Approved SECURITY LEVEL Public DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 7/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 8 ****** POWERVALUE 11 Ll UP 4. Dismantling and recycling instructions DANGER RISK OF ELECTRIC SHOCK: – CAPACITORS AND OTHER UPS COMPONENTS MAY STORE NON-LETHAL ENERGY FOR LONG TIME: HANDLE EVERY CONDUCTIVE PART WITH CARE, AVOIDING SHORT CIRCUIT CAUSING SPARKING OR ARCING. – BEFORE DISASSEMBLYING COMPONENTS REQUIRING FURTHER RECYCLING, CONTACT THE MANUFACTURER TO GET NECESSARY DISPOSAL INFORMATION; This section describes the procedure to follow for disassembly. At the end of each subsections, relevant WEEE or recycling information are reported. Remove the UPS from the carton box and make sure it’s powered off. UPS is delivered with external cables requiring selective disposal. Figure 4-1: External cables provided Make sure UPS is powered off the UPS. VRLA BATTERY BLOCKS CONTAINS HAZARDOUS SUBSTANCES AS: – INORGANIC LEAD, LEAD COMPOUNDS (Pb – CAS 7439-92-1); – SULFURIC ACID (CAS 7664-93-9 – CAUSES SEVERE BURNS). THE CONCENTRATION MAY CHANGE, DEPENDING ON THE MANUFACTURER. CUTTING OR DAMAGING THE PLASTIC CASE, WILL EXPOSE ENVIROMENT TO FURTHER WARNING HAZARDOUS SUBSTANCES AS LEAD MONOXIDE (CAS 1317-36-8 -HARMFUL BY STATUS Approved INHALATION AND IF SWALLOWED). SECURITY LEVEL Public DOCUMENT ID. 4NWD005026 REV. LANG. EN PAGE 8/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 9 ****** POWERVALUE 11 Ll UP Steps for 600VA/800VA 1. 2. 3. 4. Loosen the screws that hold the bottom battery panel (A). Remove the bottom battery panel (A). Swipe out the battery (B). Disconnect the battery wires (Error! Reference source not found.). O Figure 4-2: Remove the battery (600VA/800VA) Steps for IOOOVA/1500VA/2000VA 1. 2. 3. 4. 5. 6. Loosen the screws that hold the bottom battery panel (A). Remove the bottom battery panel (A). Swipe out the first battery (B2). Remove the two supports (Dl and D2). Swipe out the second battery (Bl). Disconnect the batteries wires (C). c c UPS D 82 c c 9 STATUS Approved 3 Figure 4-3: SECURITY LEVEL Public Remove the battery (IOOOVA/1500VA/2000VA) DOCUMENT ID. 4NWD005026 REV. c LANG. EN c UPS PAGE 9/10 @ Copyright 2019 ABB. All rights reserved.

****** Page 10 ****** POWERVALUE 11 Ll UP Remove all the screws on the base, opening the cover (Error! Reference source not found. Fan Printed Circuit Board Figure 4-4: STATUS Approved a Copyright 2019 ABB. SECURITY LEVEL Public All rights reserved. UPS content DOCUMENT ID. 4NWD005026 REV. LANG. Receptacles Transformer PAGE 10/10


FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE – USER MANUAL

OWNER GUIDE – OWNER MANUAL

REFERENCE GUIDE – REFERENCE MANUAL

INSTRUCTION GUIDE – INSTRUCTION MANUAL

ABB POWERVALUE 11 LI UP 1000VA (01) PDF MANUAL

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.